Recent content by cbr900boy

I had it powder coated. The color is not exact but pretty close.

Have you replaced the crank position sensor? Not to be mistaken for the cam position sensor. A bad crank sensor will cut the engine out while driving without any warning. Mine was caked full of oil. It was one of the things ive replaced as well which solved my stalling. To this day the...

Bringing this thread back to life! I had to note an observation that could not be ignored. My 98 with full armor and 33's gets me approximately 200 - 205 miles per full tank. No matter how conservative I drive, I don't really deviate from those numbers. After reading this post (thanks...

If you buy OEM Toyota and pay $550 or so, you would only be paying 310 for the rack because it comes with both inner tie rods which cost around $120 each. Hahaha.

These are the newer version of what I have: Bilstein 5100 Ride Height Adjustable Front Shock Set for 1999-2006 Tundra (24-261425 X2) These are the Tundra Eibachs I just installed: Pro-Lift Performance Front Coil Spring Set for 2000-2006 Tundra (E30-82-066-04-20) Yes, you have to use the...

Thanks, the struts were part of a complete lift kit from Sonoran Steel (Kit 1.2), the kit included factory TRD Tundra coils which on the 3rd perch was too much preload for my liking to obtain the height I wanted. With the Tundra Eibachs I was able to obtain the same amount of lift on the 2nd...

285/75/16 (33s)

My CV Axles are pretty new and I always use the pressure washer at the coin carwash.

I went straight to the 2nd perch thinking that if it was too high I could always change it to the 1st. I basically rolled the dice and it worked out in my favor.

***UPDATE with PICS*** Ok guys and gals, I just installed the Tundra Eibach coils (part # E30-82-066-04-20) with my Tundra Bilstein 5100s. Not to be confused with 4runner / Tacoma Eibach coils, which is the combo everyone seems to be using. I installed them on the second perch and the ride...

In the name of scientific research I ordered the Eibach Tundra coils. I will post an update with measurements and a review on how they ride. If all goes well, hopefully the mods can add this combo to the lift section. If all else fails, I will surely report back as well. Wish me luck...

Nobody has tried this setup?

Ok guys and gals, I tried searching but didn't find what I was looking for. My current setup is Tundra 5100s with Factory Tundra TRD coils. A lot of us are running with this setup. I am on the 3rd perch and with full armor, winch, and 861s in the rear. I need a little more lift up front...

I had this problem with both my 3rd gens. Just replace the whole cap and the problem is solved. Believe it or not the cap has a rubber seal that hardens over time which causes the seepage. Both are still bone dry.

Yes I did. I liked the look of it so I went with it.