Recent content by Charlee78

Hi, I've checked the systems related to your problems and they have one thing in common and that is the ground the ecu uses. It's a withe/black wire that goes directly in the ecu and it should have continuity to any body ground. that's where I would start... If all your grounds are good, it's...

hold the button all the way up and wait about 5 sec, after the window is fully closed before releasing it.

Make sure the sleeve that sits on the axle itself is centered with the axle seal when fully assembled, sometimes this sleeve moves and the center part of the seal dosen't sit on anything...

Seems to me like a busted tranny cooler. If i'm right, coolant and tranny fluid where mixed while you drove the truck making the tranny not working anymore. Chain reaction created the tranny/coolant mix go in the engine making it overheat enough to damage a connecting rod bearing wich ended in...

I also was thinking about installing tundra rotors with our calipers, is it possible?

Hey guys, I've been reading on the subject because I need to replace a caliper and both rotors on my truck. My question is this, did anyone ever checked if it is possible to install the brake master/booster assembly from a tundra in our trucks to prevent the lower brake pedal after the brake...

I did used that tool in the past but that was before we began to dismantle struts like ours. Since then we use the one bolted to the wall. The first time we used the tool that Toyota suggest on a runner strut, we broke 2 different tools on the same strut and we had to bring it to another shop to...

Have a look here:(hope this works) Maybe you have a misfire if yours is really too lean...

Just a note here, P0171 is System too lean. It is not a misfire, a cylinder not igniting for any reason would give you a system too rich... Just my toughts...

Since our struts are very hard to compress, I would go with the hydraulic one.

Sounds like an o2 sensor to me...

Ok, so your rotors and pads are made for a 4runner by Brembo? Just want to make sure I understand well...

Hey brianemc2_42, you upgraded your rotors and pads with Tundra ones and kept your stock calpers? Are there different calipers for the 4runner out there? I was sure all runners v6 with 16" wheels had the same ones. Sorry to hijack this thread, if I am wrong please, administrators, move my post...

I just realized I made a mistake, it's not a 3" BODY lift it's 3" SUSPENSION lift, sorry for that...

This is what I have in mine and WOW!: Pro BI-XENON HI/LOW Dual Beam HID Kit H4 H13 VVME - eBay (item 250716651722 end time Mar-23-11 17:57:53 PDT) Hi and low beam in hid!