Anyone.?
No one has any input.? If it was the clutch not disengaing enough would I still be able to hold the pedal in and not have the gears engage the gears.?
Parasite fuses/relay
Take this as you will. Test all the relays. Take each relay and then with a multimeter (ohm) probe the ground pin of the relay and probe the other pins with the second probe. The ground pin should only show ohms on one pin. If it shows ohms on either the power side or load...
Howdy.
1990 toyota pickup dlx 3.0 v6 2wd
I recently had shifting problems until shifting was non existent. I changed the clutch, pressure plate and master cylinder. Bled clutch and then tried shifting into gears. The shifter would not move even a bit. I split the case and everything looked...
Two vehicles of mine I tested the fuse box after many hours of sensor and ecm/ecu tests.
Basically on my honda I ended up testing the fuse box with the fuses pulled out. I then probed the battery (+) to the fuse holder and found that both sides of the fuse holder (shows voltage) grounds out.
I...
