Recent content by Clarkson!

I did this a couple weeks back and did get the DTC does (think P0420 and P0430) that corresponded to the cats not operating at the correct efficiency. Put some spacers on my downstream O2 sensors and the codes have stayed off...that being said they only do a visual check here in NC to see if you...

So getting ready to do this with my'05 so thanks for posting. What exactly is the process for bleeding the fluid at the end? Thanks again!

Thanks, I think a 1\2" spacer probably would have done the trick....think I will have to budget for some wheels similar to yours in the near future. Have some follow-up calls to make tomorrow on the body mount chop and plan on going through with it to make sure I can get this back off-road...

This is essentially what I am measuring as well...just a hair over maybe about 32 and 1\4"

Haven't measured the actual tire/wheel yet, will check in the morning and let you know what I find.

Thanks, sounds like your lift is about where I need to be. Think I will be close to the 3" mark if I bump up one more notch on the front struts.

Thanks, will give that a shot and see if we can get clear enough.

Hi Everyone, After having put in JBA upper control arms, and redoing the suspension with Bilsten 2.3" springs in the rear, and 5100s up front with what I believe are FJ springs. From what I can tell using a tape measure this has lifted and leveled me a little over 2.25" all the way around...

Thanks for the suggestion. What are you using for heat? I have a benzomatic propane torch, but haven't had any luck. Was thinking of picking up an oxy-map torch but am concerned that might be too hot and damage/warp the surface of the head.

Still no luck...the studs that were protruding are now breaking off and Im getting closer to having to drill. The problem is, even with an offset drill I dont have enough clearance. Thinking if I can just disconnect the engine mount, I can jack up the engine a couple inches to get at it, but...

Thanks for the suggestion, will give that a shot

So this afternoon I thought I would do a simple valve cover gasket replacement. Unfortunately, in the process 6 bolts sheared off. 4 of them are sticking out from the head enough I think I can get them with heat and vice grips. However, 2 are just slightly above flush with the head and need to...

Magnaflow cats For anyone who has done this with an 2005+, what magnaflow cats should I order? Little hesitant to have the old cats welded on. Thanks

Thanks Mike I saw them through an online search and was thinking of reaching out. Appreciate the recommendation, will give them a call.

Hi everyone, Think I've found a pair of Doug Thorley's for my '05 v8 and wanted to see if anyone had recommendations for a shop that could help with the install including welding on the cats. Any help is appreciated. Thanks