Recent content by cmj

Dang, mine must be REALLY old then! Thanks!

Mine are the 'old' style. Yours are the newer ones. Thanks

I have these "old style" SAW 2.5 series coilovers. Does anyone have information on these? I need to get new springs and can't figure out what rates I have. I am leaning towards getting 650 lb coils - my truck is a 2.7 with a heavy winch, bumper, and sliders. Also, does anyone have info on what...

So to update, I opened the cover for the motor and manually rotated it into the locked position. I would like to wire it up to a switch so if anyone has the diagram I'd really appreciate it.

So I'm swapping a 3rd from a 4runner in to my Tacoma. Since I just found out that I can't just swap over my manual hub tube, I'm going to run the ADD setup with my manual hubs. For the time being, I need to manually run the motor to lock the clutch. Does anyone have a pinout or wiring diagram...

If they came in 33x10.5x15 I would consider them. I'm planning on going with the bfgs again because of the low weight and longevity. The bfgs have been a great tire both on and off road

Idk man, 4.5-5 hrs each way isn't a day trip for me. I wish I lived closer to Tahoe

I'm working on transcoding them now!

Jon I have plenty of good video clips for you.. just let me know what format you want

On my taco I had this issue. I replaced the roller style rack guide with the newer glide bearing. I also put two tack welds on the steering shaft slip joint. Both made a tremendous improvement in the steering. The guide cost me somewhere around $80 and took about 10 minutes. The slip joint...

Overlooking Gold Lake

dat flex Rob needs sliders :D

One more

I thought I'd give a post run report After hours of traffic trying to get through I80 I met up with Sam (4rnnerfan) and we rallied up through Truckee and went up 89 to meet 49 around the north side to avoid the turns. When we arrived at Gold Lake, there was a raging campfire visible across the...

Shoot me a pm with your email or phone # if you want to caravan up to camp. I can't send PM's (not enough posts) chris