Recent content by colep123

All the switches I can turn up look like this

I went to replace the cdl switch on my 01 4Runner, the part number on all the forums is 84222-12010, but the connector end is different on my truck and I can't find one that'll fit! Any help would be greatly appreciated

Thanks for the heads up on that! Ill check that out tonight

Excellent. Thanks. I have a gas/ exhaust smell every know and then in the cab so I am looking for anything.

94/4runner 3.0. Passenger side coming out of firewall. I don't see the other side where this hose should be connected to

could it be coming from the top of the engine and just following a line down?

Sr5_runner, what brand light bar is that?

I found a connector last night while we had it on the lift replacing the rear springs that wasn't plugged in. Plugged it in and it seems like its going into 4wd. I goes into 4 low for sure, can physically feel it. The light on the dash will flash twice and go out, and then flicker here and...

The solenoid that controls the disengage has a consistent vacuum to it through all gears including park, and then the engage solenoid only has the vacuum in "Drive".

We looked again at it last night, reduced it down to something electrical. Mechanic friend thinks its a neutral safety switch. He thinks its the one on the back left of the tranny. Will keep updated once we figure it out

So I found some time and weather to mess around with this. I replaced the ADD solenoids and checked vacuum lines. I got the 4wd to engage while in Drive, but once shifted into neutral or reverse, the 4wd disengages. Pop it back into Drive, and the 4wd is engaged. Any thoughts?

When I heard the "click" it was just once, then when I went to engage again, nothing. Hole in a vacuum line? Ill start here and follow these lines...... of course it snowed here is CO last night and is about 15 degrees out! Ill take a look this weekend when it warms up!

I was messing around with lines. I engaged and disengaged the 4wd. I did hear a click but nothing. I un hooked these lines and what sounded like compressed air came out of the top 2 after I had turned the truck off and took the hoses off

Thanks for the reply. When I was able to get it to engage, I simply had just wiggled and pushed all of the hoses/electrical connectors at the VSV. It would engage, then quickly disengage. I cannot get this to repeat now! I will clean the connectors at the VSV and see what that does, even...