Recent content by coveboy

I don't know for sure if your 4runner has a similar system, but on my tundra (a 2009) there are wheel speed sensors on each wheel that tie into the ABS system, and I had a stick slice the wire that runs into the wheel speed sensor while I was offroad and make my truck stuck in 4low. Check your...

Nice, lucky then! Both my cv's are ripped haha...gotta get on that asap. And ordered so Pro Comp ES3000's. About an inch longer than the stock shocks to make up for the slight added lift Sent from my SM-G920P using Tapatalk

Great looking runner, and I dig the mini truck too! What all did you do to the front suspension? Just reboot it or whole new cv's? This is my first real project and I just ordered bj spacers and new shocks, and have one torn boot already, so was curious what else others replace when they work...

I wish Cooper still made the ATR, because that would be perfect for you. I got around 60k from a set on my land cruiser, and they were a wonderful tire on and off the road. My dad has AT3's on his tundra, and I like those a lot, but they may be a bit more aggressive than what you need. They are...

The daily- 2009 Toyota Tundra Sent from my SM-G920P using Tapatalk

Currently my CD's in my truck are Brothers by The Black Keys, Dispatch's Bang Bang (perfect spring/summer beach vibes), and a Bill Withers/blues mix I made Sent from my SM-G920P using Tapatalk

Thank you, much appreciated! I did my 100 series torsion bar tweak in high school, so I'm somewhat familiar with the whole ordeal. I'm away from town for a couple weeks so wont be able to get any work in on it, but when I get back gonna wind those down and slap on some new shocks and possibly...

You're right, there's definitely not a BJ spacer I figure after looking through their products and inspecting my front end. Concluding it's just cranked torsion bars, as you said. Thinking I might wind em back down to smooth up the ride after I replace the front shocks. As I go through all...

What a pretty sight!! I've always found driving a yota to be a good conversation starter to meet more coworkers. The angle of the camera has a lot to do with the 3rd gen appearing the smallest. My neighbor has a 3rd gen, and parked next to my 1st gen, their bodies seem to be about the same width...

If you don't run the blue/grey color scheme I may have to place an order at the end of the summer[emoji14] Sent from my SM-G920P using Tapatalk

Great idea, thank you! Found a few possibilities all for pretty cheap, so definitely ordering a set within a few weeks. Sent from my SM-G920P using Tapatalk

Ahh thank you very much! There does seem to be a spacer of sorts on the joint. And I definitely intend on getting new shocks as soon as possible, these seem shot. Any of yall have any suggestions on affordable shocks? or a length of shock/an idea of a vehicle I could snag a set off at the Pick n...

That blue looks so sharp, think it'd look awesome on your rig! Thought about the blue with the dark grey top and stripes? Maybe some gunmetal on the wheels?

Curious about this 4runner I got earlier this week. It's an 88 1st gen, 22re 5 speed, and I was told it sits on a rough country 2" lift. It's currently on 31x10.50r15's. I attached a picture of the front suspension for reference... So every time I hit the speed bumps (even super slow) in my...

So I just acquired an 88 4runner with a 22re mated to the 5speed, and I was curious if there were any "dangers" to running with my throttle body position sensor not hooked up? The previous owner said it was shot out, and I haven't yet tried the 4crawler steps since it seems to be running just...