Recent content by Craist

Well as it turns out, Toyota didn't check the crank pulley bolt like I had asked and paid them to do. Long story short, pulley bolt had come loose causing all kinds of problems. It has since been fixed. Thanks for all the help

fuel pressure was tested and is perfect, timing marks, timing advance, crankshaft keyway all fine. When it misfires, I can barely feel it. The truck runs pretty good, I would say its only running 5% rough 95% perfect. My non toyota mechanic used their snap-on stand up diagnostics on it and...

all parts replaced are OEM. Fuel filter has been replaced. It is going in today to test fuel pressure as I have no way to test that. Injector #2 had bad resistance and was replaced. All others tested fine and looked great.

Hey all, I have a 1998 4runner 3.4L V6 4x4 Auto 222,220 KMS. I get pending and faults, check engine light comes on. P0300, P0302, & P0305. Misfire in cylinders 2 & 5. These codes happen all the time and have for 3 - 4 weeks. Once and only once did I get a pending misfire in cylinder 1...

Thanks so much for that advice. It worked! No more issues while on gravel / dirt. I checked the universal joints on the steering shaft as well and those where fine, so was the tilt mechanism plastic ball joint.

excellent - thanks for the quick response. I will look into this and report back.

I could use some help figuring out a problem I am having with my runner. It has 220,000 kms on it. It is a 1998 Ltd 4x4. Currently I have replaced steering rack and bushings, lower control arm bushings, camber bolts, installed sonoran steel 1.2 lift, 285/75/16 duratracs, replace all bearings...