Recent content by cregan

Fin ally took care of my sagging worn out suspention and installed a Rough Country 3 inch lift kit and new quick struts on the front. Here is a before shot and an after shot.

1997 base with 2.7 and 5 speed 4wd currently at 146k and 2016 Trail Premium with 40K.

I finished adjusting the valve lash on my 97 3rz with 146k miles today.

Finally got tired of looking at my lift kit sitting on the living room floor and got it installed. Toytec Ultimate 3" lift kit

I am running windows 10 64 bit. I followed the instructions on installing the drivers on 64 bit and it worked the first time.

Version 12 listed above works great

Picked up my 16 Trail Premium with KDSS a few weeks ago. So far I have added remote start, window tint and Aries side steps. <a href="http://s1244.photobucket.com/user/cregan6318/media/IMG_0598_zpsk2z9uv26.jpg.html" target="_blank"><img...

Got my steps installed and front windows tinted.

Installed my remote start. Running boards being delivered today. Tint on Saturday.

2016 TEP Barcelona Red with KDSS and all weather floormats 37,900

I just tried to make it look even. I did overlap around half the width where I could. I purchased a 33 ft roll and still had plenty left over.

Today I installed my mini header to replace my stock cast exhaust manifold. I cut off all of the heat shield mounts, painted with high temp header paint and wrapped with exhaust heat wrap. Did not get a pic of it installed yet. Going to replace the valve cover gasket and check the valve...

I couldn't have said it better. I went with stock diameter but actually being able to get the double cardan rebuilt is a big plus in my book. The fit and finish was top notch. I will try to get under the runner this weekend and snap some pics.

Well I got my new driveshaft installed and all of my noises and vibrations from the driveline are gone!

I believe it was 440 shipped