Recent content by DDeezenuts

Driver side door cladding was removed by a car wash and I don’t have the privilege of being able to see which clips (red or blue) go in each square hole. Can someone tell me which clips go in which holes on the driver door? Mine is a 2000 if it matters. I have searched everywhere with no luck!

Used B&M 70264 cooler. Purchased in 2017. Good shape no issues cooler only ran Mobil 1 synthetic fluid…99.9% has drained out Might come with a an insect or two as a bonus Will ship or local pickup…Venmo or cash $85 shipped

Thanks but I am not asking what perch for tundra 5100 and tundra trd coils. I’m pretty sure I’m in the middle now and they have sagged under the weight of the bumper and winch. I don’t want to set the perch higher. Regardless of my current set up, I’m asking for those that have the tundra...

I have searched and searched but can not find the answer to my question. I currently have Tundra 5100 bilstein shocks and Tundra TRD coils up front. Front has settled with plate bumper and winch. Was thinking of swapping to OME 883 coils due to additional weight. Would I have to lower the...

Looking for non e-locker, 4.10, 16” wheel w/ ABS complete rear axle. Needs to be As rust free as possible and good working order (no bent axle shafts, etc…). PM me

No worries. Just looking for ideas. Just curious the link between a rough idle and ac compressor. No CELs that I know of and I didn’t have a scanner with me. It’s been taken care of with OEM parts but the owner has only had it for 11k miles and looking to sell which is somewhat of a red flag...

Well the title pretty much describes the issue. I looked at buying a 2000 limited tonight with 216k miles. Had a few issues I am trying to gain some insight on. Will do pre-purchase inspection but for the time being I can’t find any info about the issue above. I went to start the car but it...

sent you a PM...

bumping my old thread...would like to get my hands on a 96-00 4wd 4runner transmission to have as a spare. Mine has 300k and I am sure it is just a matter of time....

Does the torque converter/transmission not move transmission fluid through the cooler in 1st or 2nd gear?

I have a 2000 limited 4runner. Recently cracked the wood grain center dash bezel near the ac vent. Would like to find a replacement. Pm me. Located in Fort Worth, TX

Thanks. Love the Ozarks!

how does the tranny cooler do in low speed, hi torque situations?

Knowing that I bypassed my stock radiator does that change your thoughts at all?

Another good question, stock radiator is bypassed