Recent content by DuvallRunner

have to second Ventil8's experience. my rig started vibrating at about 63-66 mph. had the front wheel bearing/hubs replaced and it is so solid now, couldn't believe the difference. Cheers Scott

Hi NJ636 perfect timing! just ordered a set for the front of my rig. cheers, Scott

got it from Amazon for like $275 to the door. i'll see if i can do up some video to post.

Hi all, just wanted to share with you that i just installed the Gibson exhaust 18708. figured that the only bolts i needed to take off were so rusted they didn't even look like bolts... nother story altogether... man this sounds awsome!:becky: at idle, hardly notice any diff from stock, but...

UPDATE well, when washing the rig, i pushed down on the passenger sway bar near the wheel, and, yep, it was loose. replaced it and now we're ridin' tight! thanks for all the helpful replies, you guys ROCK! Scott

Whoah! i live right off Big Rock Road! been here since about 2003. when were you out here? nope, we're in an unusually dry pattern (but you didn't hear that from me!), fingers crossed. i also replaced my swaybar bushings with the new suspension, and greased 'em up, so that isn't likely.

Okay, good suggestions and great link Chaz, cuz that guy had almost exactly the same symptoms. i'll check out the stabilizer bar ends. ah the joys of a 100k+mile vehicle :)

Chaz, thanks, your observation helped. it made me think.. so i contacted Wheeler's and asked if it'd 'settle down' as the front was set for about 1.5 inches of lift and he confirmed it would come down a bit. so i'm watching it and trying to weed out any outliers as possibilities. other than...

i just drove mine a bit, and it seems like a loose plate or something, not directly related to the new suspsension... wierd! it can occur even on tiny bumps, seems that it gets excited and starts bumping, but almost like a rubbing bumping. since the suspension is brand new, i'll give it a week...

ya know, when i measured the ctr of the wheel hub to the front fender after install, it was 3 inches. i figured it would settle down to the 1.5 we were shooting for. would that make a difference?

thanks all. yes they were pre-assembled by Wheeler's Offroad. i checked the torque on the top bolts. it almost sounds like a loose piece rattling for a short bit, not too loud, just not quite right. thanks for the suggestions and i'll follow the advice given so far and report back if anything...

hi all, pretty new to the forum and have a question: just installed Billy 5100s on Toytec coils. all went okay (except the rusted nuts and bolts!!) and now i have a new clunk over small bumps. it sounds like something is loose but i've checked and rechecked umpteen times everything that i'd...

hi there, i recently did both my axles using rebuilt units. the driver side is fine. the passenger side has been leaking slowly since replacement. i replaced the seal once, still leaking. did it a second time with a Toyota OEM, worked for one week now it's leaking like before ARGH! anyone...

Hi all, i followed Settytb's great writeup on replacing my cv axles and have a cautionary tale. i followed everything on that thread and he really nailed it. every warning happened and it went like clockwork... except the seal. i forgot that part of it and just replaced the axles. the driver...