Recent content by electronics4u

Here is a picture of an engine. The piece I am referencing is the piece that is between the Master Cylinder and a fuse box. It has 2 cylinders on it with a small green cap on the far right. Any thoughts why this would be buzzing after the car is turned off? Thanks.

Hey guys, My rig seems to be struggling lately. I got it back from the shop (tranny leak repaired from rebuild). Now the truck vibrates like crazy at stop lights. I have also noticed a sweet smell when I get home at night. No fluid leaks under the truck. Finally tonight I opened the hood...

That looks totally awesome. I have a 99 and have been thinking about yanking the seats out to do this. I will have to try this in the next couple of weeks.

Fightman, if you are willing to drive down to Texas and help me with my rear seal, I will order some for you and you can have it for free when you get here. :lol:

Look at it on the bright side. It is a 4WD that has a lift kit that can be controlled while driving down the road. You could wheel in it and then lower it when you hit the street. Just add some 35's and you are ready to go. Despite the dumb lambo doors, the paint job is clean and the...

Guys, I have a 99 Limited Runner. Been looking for a scoop hood and may have found one. But before I make an offer. Will a hood from a 2001 model fit on my 99 and will my 99 hood fit on the 2001? Obviously I am looking at buying the hood off of another Runner for Sale. Who knows. I may...

Probably got it running over a smart car. :eek: I just used some rustoleum for my steps and rear bumper. I will have to tell you how it holds up. I put a ton of coats on there so we will see. Autozone does have Bumper paint so you can check that out too.

Man, I have a 99 Runner. I recently had to have the tranny rebuilt. After getting ripped by the first guy, I had to take it to a second shop. Long story short, was out of the rig for a month. People at work were sending me e-mails about buying a new car etc. etc. Once I got it back and...

Welcome. I am in McKinney. Lots of good stuff on here.

Do you still have the Gas tank and the skid plate for it? I am in Dallas so I could possibly come get it depending on where you are in OK.

There are all kinds of write ups on here for both. In fact, there are videos on youtube that will show you how to do both. A word of caution though. If you are not mechanically inclined, you could get over your head pretty quick. Though, both of these tasks should be easy providing that you...

I finally gave up. Sounds bad doesn't it? I have yet to share a pic off my runner, but let me tell you there is plenty o' rust under it.(Maine Runner) Plus I didn't have a socket that would get in there. I almost got the dremel out to cut it off, but since my wife is not a fan of me not...

I have been using it, but can't get to the inside bolt. Did you use a narrow socket?

Boys, I have been a machine today. 1st the fuel filter. Now I am tackling the running boards. What did you use to get the bolts off by the front tires, I don't have any sockets that will fit through the holes.

Holy Rusted Solid Metal. :cry2: It took no time to get to it at all. Sprayed it with WD40 and Liq Wrench. Not even budging. I know I can't take a torch to it, but man it is going to take a gorilla to get that thing out. It is still lefty lousy right? :jk: