Recent content by gaswede

Over a year ago, I bought this rear passenger wheel bearing/hub and extra parts. Never installed them bc the issue wasnt the bearing. Now I need to install it and the driver side is needed too. But.... Do I actually need to use any of the bagged parts?? If I do, that'll tell me what all I...

Someone please let me know which to splice. I leave on a 12 hour road trip in 1 day. I have no other options and the wiring diagram I posted was for a 2003 it seems. I wheel a 2007 4.0. Colors aren’t even close Thx guys!

P0328 code for bank 1 sensor 1. Intermittent issue but happens 50% of the time.

So the new sensor will just be located at the ecu? This won’t cause any harmonic issues and set off warnings again?

Ive made the decision to splice my knock sensor at the ECU after research. I just cant figure out which wires to cut on a 4th gen. Can some one tell me please? Ive seen lots of talk of how-to but no confirmation on which lines to splice. I have the wiring diagram attached.

Thanks for that great info man. This made perfect sense. Going over my data and with further research it looks like I’m an acceptable range. While my spark plugs are only 15k miles old, it may be time to pull and read them to make sure I’m not too rich.

Can someone take a look at my attachments of my O2 sensor and Cat data? One test at a time, I'm trying to systematically find a problem leading to my drastic loss in mpg and eliminate the fact that its all in my gearing. I had to delee a chunk of the temp data just to shrink the file size but...

Thanks guys. All great suggestions. I think the tab route may be the way to go.

I installed new rear 5100’s a few months ago. Noticed my rear mount pins were bent upwards on both sides. It took a ratchet strap and a lot of cussing to get the upper pin seated in the shock tower. Naturally, this put a lot of undue stress on the bushings. After some very mild off-roading the...

Thank you everyone for the replies. Safe bet is on continuing to bring the regular toolbox. Now I have a better understanding of which may be most impactful went on the trails.

Looking for a list of what sockets we need off road for our T4Rs. I hate bringing my entire socket set. Just want to throw the essentials in my recovery kit and go!

Just went back and looked at my order. Looks like I was on a late night Moog kick. I ended up getting front moog poly bushings and Dorman rubber for the rear. Oh well. All my links are Moog with the rears being the 2nd gen design. I didn’t get the greasable kits. Having the discos will be nice...

I just ordered all new rod ends and bushing myself. I went with rubber bushings for that exact reason. plenty of cushion for on-road and a little more give for off-road. I use the poly stuff for on-road vehicles only. sure, you'll need to replace the rubber ones more often but we're talking...

they've been great so far. I have about 1500 miles on them now. Im used to MT tires but i have to say, these are def the loudest tire ive ever had. I started at 45 psi, then 40, and finally 35psi until i got full tread contact on-road on these 10 ply tires. Theyre great in the rain. Havent...

tried PMing but it doesnt look like it went through. can you send me some pics of these drawers please? thanks man.