Recent content by GG2000-4Runner

Don't forget the different backing plates. There are a couple of differences, but the most important one is the hole for the adjuster. It is on the other side. I made a comparison table with images in this Google Doc: Rear axle-hub-and-brake assembly comparison - Google Docs. By the way...

Vendor for entire brake hard line set This may help those who are looking to replace all of their brake hard lines at once. LinesToGo sells the entire set for $274.99. 1996 Toyota 4Runner 3.4L Brake Lines | 1996 4Runner- LinesToGo

I ended up mapping all of the blinker/hazards wiring and couldn't find a single short, but somehow I fixed the blinker issue. The only thing I changed when I put everything back to together was the relay, but I don't understand how the relay was malfunctioning since the right side blinkers still...

1999 sr5

It was front, back, and the console, but I somehow fixed it. I pulled everything apart and mapped out every wire related to the blinkers. I didn't see any problems with the multimeter, so I don't know what was wrong. I did end up replacing the relay before I put it back together, so maybe it was...

BE CAREFUL WHEN PUTTING BACK THE FUSE PANEL COVER If you do not align the cover perfectly before pressing it back on the box, then one of those little dividers on the inside of the cover will catch on one of those little metal tabs and possibly push it into the tab next to it. When I...

Thanks, gamefreakgc! That's what I ended up doing, and then it started smoking, but I didn't hear the horn. I saw the smoke and pulled the negative off the battery. Turns out the cover panel over the circuit board had bent one of those little metal terminals on the board and caused it to touch...

Could it be too much resistance through the wiring going to the relay? You might not have to find the relay if you can access the cable. Here is a video diagnosing a similar problem on an 88' pickup with a 22RE that might help: https://www.youtube.com/watch?t=304&v=SafjO966WTA&feature=youtu.be.

Horn relay on the Body ECU Anyone know which relay on the 1999 Body ECU is the one for the horn? I think mine is stuck.

Horn turns on when the ignition is on I wrote this in another post as well, but I don't see anyone with this exact problem and I can't put up new posts yet: Anyone know how to fix this problem on a 99 T4R? My horn turns on and stays on when the ignition is turned to the on position. I've ruled...

Horn turns on when the ignition is turned to the on position Anyone know how to fix this problem on a 99 T4R? My horn turns on and stays on when the ignition is turned to the on position. I've ruled out the clock spring by taking apart the steering wheel and testing that the wire is not...

Did you find the cause? I have the exact same problem. I found the reason why no power is getting to the fuse (at least in my situation). I was looking at the wrong fuse terminal. The diagram was confusing because of the blank spot along with one of the previous owners swapping the right and...