Recent content by gridpower

What were your symptoms on-road with your worn out cushions ?

King Shocks Rear 2.5 Remote Reservoir Shocks w/Adjuster for 4Runner / FJ Cruiser Purchased new from Mudify on 11-18-2024 and used for only 3000 miles. Removed these so I could setup my 4RUNNER back down to stock suspension Some slight marks here or there, but overall looks great. Stanchions...

I have a set of ToyTec's 1inch perch lift made to replace the stock perch on the 4Runner TRD Pro Bilstein coilovers. This will yield about an inch more of lift in front. I found that it also stiffened up the ride a little bit without affecting too much of the up travel being only a half inch...

Toyota 4RUNNER 5th gen TRD Pro - Toytec 1" front lift spacer Toytec 1" lift spacer (bottom spring perch). Used, but mating surface to spring is pristine. Part number 90513. New retails $160.

PRO-LIFT PERFORMANCE REAR COIL SPRING SET FOR 2010+ 4RUNNER - $75 1 INCH REAR LIFT Eibach’s Pro-Lift rear coil set for the 2010+ 4Runner. Rear Springs These work for Toyota 4Runners 2010-2019 Used for only 10K miles. In great condition. DESCRIPTION +1.0 in LIFT Increased Ground Clearance...

Thanks Joez... I have KDSS on my TE and the initial plan was to go with both circlips on the top slot as others have suggested. But, if I go with the Toytec spacers, I wonder if I could get away with placing both circlips on the bottom slot? Maybe I may get right at 2 inches of lift? Those...

When you installed this kit with the Toytec spring spacer, did you use the bottom circlip slot or the higher one? Also, did you install a diff drop kit or is it even necessary? Your CV angle doesn't look seem to look be overly steep in those pics

Are these required to install this new TRD PRO kit on a TE ?

FS: 5th Gen 2014-2017 Rago Fabrication 30" hidden light bar mount - Nashville, TN FS: 5th Gen 2014-2017 Rago Fabrication 30" hidden light bar mount These brackets allow you to mount a 30-32" Single or Dual Row Straight LED light bar in the lower bumper of your vehicle. This mount will not...

OK I figured it out. When you are driving with the lights on, move your dimmer switch down past the click. Then go to apps, setup, display, general and here is where you adjust the brightness contrast when in night mode (i.e. Lights on and dimmer switch down) This is a separate setting for...

In my 2014, I can't find a DAYMODE setting . Funny this is, when I move the dimmer wheel down the NAV goes into dark mode but continuing to adjust it down doesn't change the brightness of the dark mode on the NAV. It only affects the dash lights. Basically there is only 1 level of brightness...

Does anyone know if you can change the navigation screen at night to the brighter version of black background with the lights on? If I turn the dash dimmer down it changes from white background to black... Then if you change the dash dimmer to full bright (wheel clicks) the dark background...

Do these kits come with the trim removal tools or do you buy those separately?

Got the LockerDown from Amazon.. thanks for the tips... fits perfectly.. Sent from my iPhone using Tapatalk

Do you lose access to the 12v lighter outlet inside the console? Sent from my iPhone using Tapatalk