Recent content by gtg339y

Bamagolds did lubing the zerk fittings work for you? I’m having same issues as described in this thread

Thank you everyone. So after driving around for a few days it finally came out of 4HI and went back into 2WD. A couple days later I tired to go back into 4HI again to see if it would work properly. It got stuck again. I just dropped it off at the shop that did the services a little over a...

Thanks man. Already tried all that. No luck. I was thinking actuator too but it worked just fine right after leaving the shop and getting fluids changed . It was about 6 hours later when I put it in 4 HI again and it got stuck. So it’s weird that the actuator would have worked and then not...

Would love some help. Drove it around for about 50 miles today. Still stuck in 4 HI and lights are blinking

I went and had my front and rear differential and transfer case oils serviced today. Afterwards I engaged 4 HI and drove with it on for a little while to make sure there were no issues Then I turned it back to 2WD. No issues. Later in the day I tried to engage 4 HI again but it never...

Thanks!

I am looking for front and rear springs off a 2007+ FJ 4x4. PM please. Thanks.

Hey guys, I read this forum a pretty good bit, but don't post too often. After about 8 hours of research I have decided I want to do the FJ coils/Bilstein 5100 mod. I am trying to decide if I can do this myself or not. Basically my questions are: 1) Is there a good step by step install...

Thanks for the info. Chaz--is my 4runner not set up for HID's since I have the projector housings? From reading on here I thought the blinding/aiming incorrectly issue was with 2005 and previous models because they didn't have the projector housings?

Hello all, I just got a 2007 4runner Limited 4wd and I am thinking about changing out most of my exterior and interior lights. I guess my questions are as follows. 1) Would replacing my headlights with these Philips HID lights ( Xtreme HID 4300k Philips Xenon HID Conversion Kits ) be that...