Recent content by hilander07

Thanks Singtoe...it ended up being a stretched right front speed sensor wire (actually both wires). Soldered & heat shrinked new sections of wire and no light. Cleared code, test drove and no codes. Thanks again to this great forum!!

They all appear OK. Do I need to remove them to check the OHM reading or just unplug? What values should they be? Would a bad sensor cause the cruise light to flash instead of the abs? Confused by this.

Thanks for the response! Would rather no give it back to him with the light on. It has a 60A fuse and it doesn't appear to be blown.

Hey All, Great forum! Need a bit of help. Working on a buddies 2000 4Runner V6/Auto. Installed new front inner/outer CV boots and rear inner axle seals. I now have an ABS light on. Not sure if it was already on. I tried jumpering the E1/TC ports, but only get the cruise light to flash, not...