Recent content by isdriven

....your 4Runner...:hail: Hi, I'm going to tackle my DT LTs starting tomorrow, if you are interested, we can exchange notes. I've done this once before, on a 2003 Tundra. I replaced the manifold with and oem style unit. Yes, it's a pain. I have already started penetrant applications to...

Is there anyone in the Harrisonburg VA area that could let me barrow a jack and jack stand and perhaps a few tools? I'm in a bad way. Long story short, I'm down here on vacation with my grandmother, mother, wife, and son. We are from MD. We are staying at Massanutten Resort. I have a brake...

Jason, is there a solution for those who want to run the long tube and still pass emissions? I just need it to not kick a CEL, no physical inspection in my state. Thanks!

I'd go but I have a bad head gasket. :cry2:

Hey Pasha, That's not a hard install to do. Those kits a re usually plug-n-play. There are a lot of videos on YouTube if you are unsure. Get yourself a pack of long zipties and a wire cutter and go to town!

I have a 12v (and battery capapble) Porter-Cable air pump that I am happy with. It's a little slow but it does the job. It is light weight, It also has a long enough power cable to reach, and is easy to use. It is and air pump with onboard tire infiltrator so, it is multi purpose. Good for...

They may say something about your lift, depending on the inspector. What part of MD will you be in?

Keep in mind, Napa shops are their own franchise. Each one is run differently. The guys at the Napa I go to are on point. In regards to the painted Napa calipers, after 2+ years the paint is still holding up. It's not glossy or anything, but it's definitely not rusted.

Yes, that is correct. I'd be fairly certain that their re-manufacturing process and hardware quality is the same for both types. IMO, the hardware and tolerances that are used in the re-man process is what is critical, not so much the caliper body itself. Most of the bodys are Toyota anyway...

Not sure how soon you need the info but, in a few weeks or so, I'll be taking off a Napa caliper that I have been running for about 2 years and I can give you some feed back on long term use. I am doing a full 5th gen swap as well. I don't think I have an issue with the Napa caliper, it's just...

I'm going to ome 885s for a little less rake and body roll in the front. I'll also be able to lower the coil to gain a little more shock travel. I'm on 896s in the rear already and it's not a well balanced setup and I would not recommend it unless you are towing or carrying a lot of weight 80%...

Bump:peep:

I have some front FJ coils for sale...cheap. IM me if interested.

I think calling him would be your best bet there. He is working with the guy who was involved with the design of the TRD supercharger. I would think he could tell you quite a bit.:ear::blah: You know I did not ask but I will try and remember too. I am thinking the 03-04 would be supported...

So not too much to report form URD. It's like Gadget said, there is still work to be done to fine tune the prototype. We were able to get the engine management software designed for the tundra 4.7 to work with my 4runner. URD's current focus is to be sure that their software is operating and...