Recent content by j_2000_limited

Replaced Faulty Upstream A/F sensor Was getting a P0125 stored and P1130 Pending codes on my vehicle. Dumb dumb at o'rielly tried to tell me it was the thermostat. Did some research and made the painful discovery my vehicle is a cali emissions and required the doubly as expensive A/F sensor...

Hello, Quick question regarding the oem tow points and tow hook on the 3rd gen 4runner. Is the mounting pattern between the front and rear the same? Can I use a pair of extra RH and LH tow points from the front on the the rear of my vehicle?

hell yeah brother

I purchased this WAAG branded 1 piece brush guard off of FB Marketplace that the seller advertised as for the 92-2002 4runners. Today after attempting to mount it, I believe it is not compatible with my 2000 Limited 4wd. I am unable to located much information on the internet about it aside from...

I do not have a manufactured one no, but I 3d printed my own (I recognize that the increased elasticity will reduce my hammer hits effectiveness). Honestly the seal fit was so tight that I do not believe it would have helped, the friction was simply too much to overcome.

After noticing gear oil leaking from my transfer case on my 2000 limited 4wd, I have been diying the seal replacement (with no access to a lift). I have successfully replaced the seal for the front output shaft as well as both companion flange seals, but have been struggling to seat the rear and...

15 I believe

hello

congrats and same

welcome

hello from your neighbor in washington

hello future friend

Hello My Name is Jack and I am lucky enough to have come into possession of a 2000 3rd Gen Limited 4wd. I have been attempting to do some work on it given it has 175k on the odo but thankfully it was fairly well taken care of. I have replaced the alternator, battery as well as all the fluids...

welcome back why did you depart?

backwards yeah this attempt to declutter the forum seems to do the exact opposite