Recent content by jacob7071

Selling 1 pair of BORA 0.75" wheel spacers. Asking $60 + shipping. Located in Houston. More pics available upon request. Ask any questions.

Sold

Selling one pair of Spidertrax wheel spacers. They're ~2.5 yrs old. Nothing wrong with them. My new tires stick out farther, so I replaced these with smaller spacers. Asking $100 shipped from Houston.

You shouldn't need a spring compressor for a 1/2" spacer unless you're trying to put it on top of some lift springs. I installed 1-1/2" lift coils with no compressor, so there's definitely room for stock plus 1/2". One thing you might try is use some duct or packing tape to hold the spacer in...

PM replied - I think. I don't see anything in my sent folder.

I used this in my 3rd gen to monitor transmission fluid temps after installing the external cooler. The 3rd gen has been sold, so don't need this anymore. Asking SOLD

Selling a pair of Dobinsons C59-505 rear springs for 4th or 5th gen 4Runner. I had them on my '21 limited for about 750 miles, but it was more lift than I wanted. They provide ~2" of lift on a 5th gen and ~1.5" of lift on a 4th gen. SOLD.

Selling a Daystar 2.5"/1.5" spacer lift for a 5th gen 4Runner. Bolts for the front spacer thread onto the existing studs, so no need to disassemble the strut to press out / press in new studs. SOLD.

Whatever you do, do this! Insurance companies are businesses. The more they pay you, the less profit they have. So they may try to lowball you. But they (most of them) also know how to be fair. I'd find another '21 limited for sale and show the insurance company. Make them give you enough...

I do have the more popular one. Looks like the other 4Runner UCAs are for drop kits. I wouldn't mind 4+ deg of caster. I just didn't want 4.5 on one side and 3.5 on the other. Took it back for another alignment yesterday. This report looks even better than the first one. No noticable...

I would still think, even with it lifted, you'd want camber and toe in spec, right?

I did check the tie rods when I installed the lift. Everything was tight, and truck only has 22K miles (and 2wd with no offroading) so nothing should be loose. The pulling after the first alignment could've been due to crown, but I took it back anyway. Pulling after 2nd alignment was...

Tires are KO2s with less than 60K miles. They are wearing a little unevenly which has caused some balancing issues, but no pulling prior to the Dobinsons lift.

I have a '21 Limited 2wd, and I recently added Dobinsons C59-302 / C59-505 for a 3/2 lift along with JBA UCAs. I had the alignment done, and I've never seen a more perfect alignment report. But, the truck was pulling slightly to the right. I also had 1/2" driver's side lean, about 2" of...

Thanks, but I meant how long will they last sitting on a shelf uninstalled while I wait for my XREAS to wear out? And does it need to be climate controlled? Or can they sit in an attic in TX?