Recent content by jahmes143

Not possible on the 04. It runs an older non-CAN protocol. Unfortunately.

You want Tacoma/Tundra CAN. I don't have a pic, but I bought one of the 3M mounts from UG and mounted mine just above the interior lights dimming roller switch...in between the AC vent and the tach gauge. I feel like I had to trim the sticky mount a bit to get it to fit, but I don't 100%...

Modify Street 180W 60 High Power LED Spot Driving Lamp, 31.5- Inch. https://www.amazon.com/dp/B00FWOKKGI/ref=cm_sw_r_cp_api_U2l6zb46HYR13 ^thats the bar I used. Sealed all the edges and screw holes with clear silicone just to be safe.

I think you should be fine. I have a similar spacer lift (on a V8) and have pulled that similar load just fine. There is some "squat" but it's not bad. If you wanted, you could get a weight distribution hitch. When set up properly, they completely level out the tow vehicle (eliminating all...

Which part are you yepping?

My 04' V8 Sport 4wd specs are as follows (I think): GVWR: 5,710 Curb Weight: 4,515 (includes full gas tank, but no driver or passengers) Door sticker: "Weight of cargo and occupants should never exceed 950" I'm confused. According to the door sticker, the payload is 950. But according to how...

Haven't driven it yet. I used genuine Toyota WS fluid. Got it on eBay a lot cheaper than thru the dealer. Sent from my iPhone using Tapatalk

To clarify, I turned the vehicle on for 20ish seconds (until I drained about 2 quarts into a milk jug). Then I used the pumper to add 2 quarts through the return line described above (rather than into the tranny fill hole). The piece of hose attached to my pumper fit perfectly inside the tranny...

I ended up just using a 'regular' fluid transfer pump. Like the one you get from AutoZone for $10 that you use to fill your differentials. Functions like a soap dispenser. Worked fine. I exchanged exactly 12 quarts. I intentionally overfilled about 1/2 quart and then let it exit via the overfill...

Hey all, about to change the tranny fluid on my sealed '04 V8. I'm going to do the "flush" method where you pull the hose off the tranny cooler. My question is this... Do you NEED to add fluid to the fill hole in the tranny, or, alternatively, can you add the fluid to the rubber hose you...

31.5" bar. Light blockage is minimal and not noticeable. Maybe 10%??? Didn't increase engine temp. I have a ScanGauge and my engine temp maintained 194 degrees before and after the install. Sent from my iPhone using Tapatalk

Thanks for all the replies. No, not necessarily required to purchase from a particular dealer, but the family/friends discount available through the local dealer owner seemed to be an attractive deal. Test drove an XC90 today and as some of you noted, the creature comforts on it are...

Lol that bronco does look pretty awesome! Have you seen the new Challenger SRT Demon?! Supposedly it runs a 9.4. Sent from my iPhone using Tapatalk

I wasn't sure if that was an option or how much it would cost. Obviously it is incredible overkill, but it would bump up the resale value down the road This is a situation where anything less than $50k will go to Uncle Sam. So might as well spend it because you're not 'saving' the unused...

I know. I call it the stealership. Recently got a quote of $700 to change an 02 sensor. Thanks but I'll do it myself and save $600 in 20 minutes.