Recent content by Jarheadoo7

Came out of a 2015 trail premium. The OEM mirror turn signals. In excellent used condition. 25 bucks shipped to lower 48. Send me a PM.

I have one set of 2 a spidertrax 1.25” and one set of US WHEELADAPTERS 1.50”. Sold as a set. I am currently running this setup and I’m only selling these extra ones because I don’t need them sitting around. This staggered spacing allows for minimum rub on the front and wide ass with on the...

For 10-20 runners. Weathertech brand ventvisors. In channel, I believe these are the slim design. I bought them used and wrapped them in Saran Wrap to protect them from box scratches while stored until I could remove my AVS and install them. I’ve decided to keep the AVS and sell these. 20...

There’s gonna be all kinds of opinions but the Econocraft Battery 24F-E is the most basic direct swap for your rig. I have a 15 TP and just threw it in. It matches the stock specs and starts the truck. If you have lights and winches and other accessories then a battery upgrade is prob a good...

Ewww

Pm sent.

I run WAUSA 1.5 spacers on my rear end. No issues. Make sure you’re anal about checking torquing, rechecking and telling shops not to blast the lugs with an impact.

I had an annoying pop like that. My solution was to remove my Icon UCA’s remove the bushings, re-grease them and the sleeves and reinstall. I also found the zerks in the UCA were clogged which was the cause for the rebuild anyway. I did not need to remove the upper ball joint to do this but I...

Yeah. The front body mounts hold the body to the frame but also act as shields in a front end collision to prevent the wheels from smashing through the sheet metal. It’s best to keep them as strong as possible

Test those samples on complicated areas like the sharp angles or compound curves, then remember that in the real install you’ll be using material that’s quite a bit larger and if you screen it up you’re eating money in vinyl. You’ll get a good idea if you want to tackle the job yourself or not.

Why would you pay 20.00 for a piece of vaccuum-formed plastic that prob cost less than .10? Because I tried to make one a year and a half ago. I bought a vacuum form and several hundred dollars in plastic material. After several attempts of poor and good quality molds at best, I was left...

This topic has been discussed before. There really isn’t a mod or a quick solution without reframing the seat and doing some serious fab work for merely an inch or at best 2” lowering gain. I’m 6’4” and have the sunroof. My head bumps the headliner so I’d love if there was a quick mod solution...

I followed a typical painting scheme. -Primer or promoter 15 min flash second coat if necessary, or let dry to handle and wet sand. - Base coats 15 min flash between. - clear coat 15-25 min flash between. Light coat then heavier as you build the coats. I waited about two-three days before...

Update: Took off the rear spidertrax and swapped in 1.5” from Wheel Adapters USA. I’m happy with the stance. No performance issues. A few months later had my tires balanced and rotated by the local firestone. I told them not to hammer the lugs on and to keep it at 85ftlbs. When I got home I...

Honestly, get some black electrical tape until the ebay sellers catch on to the demand. No one will notice and if the tape starts to fall off due to weather it’s easy to replace.