Recent content by Jcol8896

Engine Rebuild - The Final Boss This was the final significant project for my 4runner build. The engine had 280,000 miles, but the previous owner swapped the left and right head gaskets during the installation. So I had to run no thermostat and had a slow leak on the rear main seal. Decide to...

Paint, Tires, Rims, Tint Almost to the end of my 1997 4runner build. I started this project in 2021 to build the best 3rd gen I could, almost full restoration. I'm moving to my final project, a full engine rebuild. This last month, I got most of the car painted, new rims and tires, and nano...

Tommy is Legit I just picked up two filters from Tommy, great guy! I've been looking for this mod for so long, thanks for posting all info on where to get it.

I had previously replaced my coil packs, and later replaced my injectors but those are not required. I bought my supercharger with the kit URD 7th gen injector kit.

4Runner Build My 4runner; was built for long-distance travel and living.

I can't wait to see that one! Another item with little video content online is the 7th gen injector kit install, a somewhat uncommon and pricey mod. Besides those two things, you had a video for every item I did; that was super helpful.

Here is a picture of the door. In green is the access hole you'll use to put the sound-deadening inside the door. I covered it once the inside was completed; I also removed the clear plastic sheet that covered the front of the door. In red is an area where you need to be careful that the back...

The doors and the trunk take the longest. Unlike the floor, you can't use full sheets at a time, with lots of cutting for the doors. For the doors, I used kilmat and foam inside the door and on the front when you remove the door panel. Lastly, I used foam on the back of the door panel itself. It...

Sound deadening complete Finally finished fully sound deadening the car. Removed all the interior and panels to installed the deadening materials. Used Kilmat, foam, and mass loaded vinyl for the interior floor. Just Kilmat and foam for the doors. This project was one of the most time consuming...

Hey Tim, I've used your video guides for almost every mod or repair I've done. The only video that I couldn't find a tutorial on was the Long Range America extended fuel tank install. I know it's not a common mod but there is really no good guide anywhere on the internet. Thanks again!

I've had a good experience with mine. If you ever have problems you can easily swap them out at the auto parts store you purchase from.