Recent content by Jeff.Denson

I considered that, but I'm not sure how the paint would hold up when peeling the dip off

I've heard some bad and some good about macco which is why I went there first, unfortunately this will be a costly repair to get done. And being a broke college kid I prob won't get it done for awhile :/

2200 for the whole truck! I would prob take that with a 5 year guarantee

It is a 2006

Thanks I appreciate your advise!

I noticed a month or so ago that my passenger side clear coat started chipping. No idea how it came about, but needless to say I've owned my 4Runner for around 2 years and didn't expect this to happen so I've been down about it. Took it to a macco near my house and was quoted 1k! Which seems...

No problem! Took me awhile to finding out where it went but it's a quick fix

Yes, did it fall from the driver side? It helps with the air flow when air is going to the floor. Take a flash light and look up above the pedals you'll see a hole where it plugs into. Mine fell awhile back and I didn't get around to putting it back in until recently. Should take about 5 min...

Awesome! I have been looking at doing this aswell! How does it charge?

Thanks guy!

Bump Any one have any idea?

I have had a buzzing in my glove box for awhile now. And have been researching it on these forums and others trying to figure it out. I've gone from blend door to blower and now I think I've determined that the issue is with the air flow direction control servo. I can adjust the temp of the ac...

I'll take the blend door actuator

Found these on Amazon and looks like just what I've been looking for to add a couple usbs in my runner, CH4x4 Toyota USB Power Socket https://www.amazon.com/dp/B00QL6PIZ4/ref=cm_sw_r_awd_.0UMvbFPKV6NM I'm looking to install them in my center counsel And I am no electrical genius here so...

What did you use to get the seat out and cushion out? I've had problems with mine for awhile now but the last time I tried to take the seat out it was bolted in real well haha