Recent content by Jeffh1988

I have a rebuilt 4runner 4wd driveshaft. Spicer joints in the cardan and moog for the rear. https://phoenix.craigslist.org/wvl/pts/d/1999-4runner-4wd-driveshaft/6710108470.html Price 150 obo

I called up toms today while I had some down time and scramble is right 420 so I got my dementions and I am going to call them back tomorrow and place my order. I just want to drive this damn truck already. So many new parts and it just sits in the driveway. I will let you guys know what goes down.

It's apart right now I took it to an automotive shop they said they should be able to get it done but after taking it apart they noticed the bearing cups from the u joints I provided were too big. So I'm getting impatient waiting for a phone call back. And I'm thinking that I need to resort to...

I just called Tom woods and left a message. I might go this route if it isn't horribly expensive. The way I look at my situation is I did a lot of things to my truck. From spark plugs all the way to timing belt. Full better then oem suspension rebuild and all my preventative maintenance. And...

K2540 I'm trying to find where to buy the k2540 u joints from. I tried amazon, ebay and googled it no luck. Where does one buy and if they have the clips that go on the outside my cardan has the clips on the inside will it still work?

Hey everyone, I'm in a little pickle right now. I have a 1999 4runner with 4wd and want to know what people have done to rebuild the double cardan joint on the rear drive shaft. The one moog sells/makes (285). It fits the rear but not the front of the drive shaft. I don't want to shell out for...

Would like to buy 3rd gen oem drivers fog light. I have a 1999 4 runner limited so anything that would fit that. Pm back or email would be cool too. Thanks [email protected]

I love having this generation 4runner. I go to the yard sometimes in Phoenix and am able to get what I need but today I finally was able to locate a set of headrest for the rear In tan leather. But I took the fronts and they fit and are adjustable then I was able to find a working armrest lid...

I ended up taking my truck to a shop to get my a/c looked over. Replaced my a/c compressor and dryer. Took a lot of money to get done. Got in the truck started it up and it was cooler but not cold. So I thought well it is 113° right now so drove it the long way home and it still wasn't blowing...

I have a 1999 with auto climate and that part is called or at least from what I understand is the blend door actuator. It's simple to remove just a few fasteners hold it in. And it has a big gear inside that strips out. If this is the problem like it was with mine all you do is take it apart...

Im in the same boat as you I just picked up a 1999 4runner limited with 253000. And as far as priorities you will do your coolant and transmission fluid when you do the timing belt so few birds with one stone there. Then lbj and ubj as well all at once with inner and outer tie rods. Then you...

I would like to add to this thread. I recently just picked up/bought a diamond in the rough. Mine is a 1999 4runner limited. Needs lots of little things. But did this rear sensor today and after pondering how to go about this all morning what I did was took the hood off set that aside then...

I got a lot done on the 4runner today. Swapped out my steering wheel mine was completely trashed so went to the junk yard. While I was there I found a cargo cover, factory radio, better steering wheel and clock all for 50$ I love a deal!! So put all that in the 4runner then later on I found on...

Welcome from Glendale az

Is this still for sale?