Recent content by john99900

Just got the OEM Toyota insert for my rear wiper and it took about a couple of minutes to change. Just turn the rear wiper on and turn the key off when the wiper is pointing down. Then just pull arm back a little and slide the old insert out. Take the two metal slides off the old insert and put...

Excellent write up! My factory wiper blades started streaking after about 38,000 miles, so I started looking at replacing the front wiper blades. I read all the reviews on different brands and all the posts I could find on this forum. I decided to just replace the factory inserts since the...

My back wiper stopped working a while back and I had just forgotten about it when I took it to the dealer for an oil change. Well after I got it back after the oil change, I tried the wiper a few days later and it was working. I was thinking how great it was the dealer had fixed it for free. So...

Awesome glad you got it working. Looks great!

Here is another pic.

I used a solder station set around 520 degrees and used .032" rosin core solder. I didn't use flux either. Have you checked the ribbon cable going to the control? I would try reseating it and see what happens.

There is an led under the ignition ring. If you pull off the lower dash, you will see it. I had some black tape I had to pull off to see it. Be careful as there is some very thin wire going around the ring where the key goes. I am going to do mine once I figure out how to get to the led.

I used 3mm but I would think 5mm should work also. I recommend using the 3mm instead of the 5mm because even with the 3mm it is really bright. What I did was use a 9volt battery with a couple wires taped to the positive and negative terminals. I then soldered a 50 ohm resister to the positive...

I did my HVAC controls, rear window and 4x4 switch this weekend. I did the arrows for High and Auto in Red and the AC in blue. The rest of the arrows are white. I also did red for the rear defrost and recirc buttons. If you look close, you can see I did the air bag ON light in blue. I am going...