Recent content by jsnppp

Didn't see this in time. I did look for the other harness connector but the junction on the back of the fuse box wasn't hard to work with. All good - and thank you again, your post enabled this to happen.

Got it going! This was the clue I needed to get it done. Once I removed the fuse box I was able to flip it over to find the connector with two side by side wires - red and red/white. Spliced in the keyless entry wires and I'm good to go. Cheers - Jason

I searched for IF1 and then 1H and found this for the connector. At least I have an idea of what it looks like: Door unlock/lock problem Thanks!

Wow THANK you. I didn't know what the gray box meant, super helpful. Is the 1F1 harness just a junction between two harnesses behind fuse box? Is there an identifier on it? I'll just look for red and red/white wires at a minimum.. Jason

Ok - it appears that the entire diagram is for B16 which is the plug itself as per this thread: HELP identify this part However, I'm concerned that the wire colors in the diagram don't align with what I am seeing on my B16 connector. The diagram appears to show Red and Red/White wires for...

It's possible that it is the pin number above the wire, but the colors don't align...

Hi all, I'm tired of futzing with programming the remote key fob so I'm adding 3rd party remote door locks. I have the FSM which shows the lock/unlock signal wires going to to the BCM. Photo attached. My challenge is that the wiring labels in the diagram don't match my vehicle. I believe the...

Thank you 3bears. Dang, looks like I put them in on the wrong side...

Not to thread jack but I install stock OE '99 Tall springs on my 2002 4Runner and still have a bit of a drivers side lean despite 100% new everything on this list. I see that someone specified front "Blue Yellow" for passenger side. I have my blue yellow on drivers side, and red yellow on...

Have 265/75/16s on my 2002 4WD SR5 automatic w/ 99 tall springs and poly bushings everywhere. I'm not unhappy with them, I feel they are quiet, by that I mean when the road surface isn't rough/etc. I can't say I hear them. Prob have 10-12K miles on them put them on about 3 years ago. I'm mostly...

I recently tracked down a funky creak when turning on my 3rd gen. I did two things at once and so I can't be sure which one. 1. I torqued the lower control arm bolts to 130 ft lbs. Manual says 100 and I feel mine were less than that. Folks on this board said they loosen over time. 2. I...

Love this! Excellent mod and write up. Thank you. Next time I'm at the wrenchapart I'll take a look. Jason

Those are the exact rims on my 02 Sport and I have no reason to think it's anything but OEM. 16" right? Jason

171K on my 2002 SR5! Looking for 171K more!

Nice truck. Worth saving. I had similar rust on my '02. I chose to cut out the rusty holes and create a direct fit patch panel, then butt weld. Prior to this I cleaned all external surfaces to bare metal, used OSPHO to convert, clean thoroughly, etc. After patch panel welded in I primed and...