Recent content by Justin.Geer81

Yeah man ... I dunno ... I think the front is less of a issue in my humble understanding ... the back axle is solid so it can push on, or affect, the other side ... with an independent front suspension i wouldn’t think it was as likely to force extend it ya know? Gravity is the only thing that...

I am running a revtek leveling kit (so no suspension upgrade) ... 2in rear and 3 in front with a dif drop ... nothing else as far as UCA’s or anything ... I was planning on doing a full suspension upgrade sometime next spring or summer ... but for now ... that’s her! Attached is what it looks...

Want vs need man Of course I don’t want less travel ... I get more=better ... but when a company like toytec recommends it for lifted 4runners due to how the axle travels ... then I start asking questions ... they even make a block to keep the stock suspension from over extending (I believe it...

Just recently installed 34’s on the runner ... found that it seems to articulate too much ... causing the tire to go to far up into the frame So I ordered the toytec drop\relocation kit along with the aftermarket durabumps for the rear In installing them ... it doesn’t look like I should used...

The beasts look amazing! But the damn things will hold 80 psi! Have them at about 35 right now ... just wondering if I should be running them higher? I’ve always run the sidewalk psi ... but 80 just seems so damn high Thoughts? 285/75/17 size on a 4runner obviously ... Sent from my...

Thanks man! That should do it! Sent from my iPhone using Tapatalk

It’s been bugging me for awhile ... and I finally got around to taking off the flaps that I figured were causing it ... and viola ... no more rattle! I started noticing it a loonnng time ago ... right after level/lift kit from revtek was installed. These are the engine bay shields right in...

It’s summer ... and I didn’t really think about it ... but I know A LOT of you have done this ... and it looks amazing. But is there any problem with snow build up behind the bumper/fog light area? Cuts have already been made ... just wanna know what I’m in for Sent from my iPhone using...

[emoji848][emoji848][emoji848] ... interesting ... makes me feel a little better then ... lol ... I really thought the shop didn’t put it back Sent from my iPhone using Tapatalk

Is the 4runner supposed to have a ‘shield/cover’ on both fogs ... seems to me like there should be ... however I never had both ... wondering if the shop that lifted it took it off one side and didn’t replace? Especially now that I’ve cut the inner fender well and bumper for clearance My...

No issue with the cutting ... it’s welding on of the plate I don’t have the equipment to do. Is it even needed? Sent from my iPhone using Tapatalk

Specific places I should be looking into? ... BMC needs to happen Like who will actually do that? I’m in Boise,ID Sent from my iPhone using Tapatalk

It’s right by the front bumper ... back is fine from what I can tell ... just the front ... which I will take care of ... just surprised me is all Hadn’t heard of anybody rubbing with 265’s ever ... and I want to put 285’s on in real soon ... at the smallest ... so I guess trimming is just in...

Easy install ... looks great ... but I noticed when I backed out that I’m rubbing now I’m lifted 3 in the front and 2 in the back ... didn’t think I would run into that quite yet ... it without bigger tires ... still on the stock 265’s So how y’all fitting the 285’s and bigger ... is...

Hello all! I just noticed that from the top of my tire to the fender I’m sitting an inch lower on my Drivers side vs the passenger??? I have had the REVTEK 3in raise kit basically since I’ve had the rig ... I know this can’t be normal ... any idea what caused this (at the risk of sounding...