Recent content by kakarot

Looking to buy both rear axles with ABS for a 1998 4runner.

Thanks man I will moved it to the correct forum.

Will post some picture this week. Selling my 98 4runner limited as is for $2800 (OBO) Info on the car the good 224000 mile Car still run in perfect condition Timing belt,water pump all 3 belt has been change last year.(OEM) new use alternator, rebuild starter. (OEM) Front break just change rear...

I am not a mechanic but would look into these first. This is based on that you did not add anything to the car and it was working before. If when you start your dead car and you hear a clicking sound but the car does not start and it will take a couple crank to start the car, I would check...

Have you try a spark test to see if you are getting enough spark. The coil pack and the spark wire may look new but you can't see the issue with the eye try to isolate little thing first. I have the same issue as you multiple misfire P0300, P0301, P0302, P0303 I did a spark test on cylinder#1...

I got the code about 3 week ago I have not done any replacement part yet. I just replace the spark plug(NGK) and did the basic trouble shooting with the multi meter. I'm thinking about replacing the coil pack but like I say in my OP I wonder if I just replace the spark plug boot would that make...

My 4Runner 1998 V.6 with 217k I had a misfire on 3 cylinder 1, 2 and 3. TB and water pump has been replace at 157k, Alternator just replace, starter is rebuild. Here is what I have done so far testing. 1. Replace spark plugs (NGK) and ignition wire (NGK) 2. Test ignition coil resistance...

You might have miss something/forgot something when you put everything back, If I was you I would removed everything and double check the work again to verify the install again.

Everyone has their own way of doing it. There is no right or wrong way. Watch this clip from this mechanic and we will learn since we are not a certified mechanic just a DIY. How To Replace Your Brake Fluid - EricTheCarGuy - YouTube Here is a PDF file brakes bleed sequence.

1. Bleed the brake in this order Front Driver-side, Front Passager-side, Right(Rear)-side, Left(Rear)-side. 2. Do the brake in if you replace rotors.

Squeaking noise at full lock: I took a look at your video and it is definitely your PW steering pump going bad. The whining noise: I would say it is your drive shaft going bad. Go under the car and turn your front shaft with your hand and listen to the noise. Jack up the rear end and do the...

You can eliminate the stereo because the stereo is original and the power is off. Lub you drive/Prop Shaft and you will be good to go.

My noise only comes on when the car is moving at any speed while pressing on the gas peddle. The noise does not come on when you park the truck and giving some gas. The way I figure this was 1. I eliminate all wheel (jack the 4runner up spin the wheels) no noise 2. Park the truck give gas no...

Hulk311, Here are the two website that I follow both of these guide are very helpful: http://www.toyota-4runner.org/3rd-gen-t4rs/97006-drive-prop-shaft-greasing-guide.html 4Runners.org - Lubing Your Driveshaft

I figure out my noise was it was the drive-shaft after lubing the shaft everything was back to normal.