Recent content by Killer Squirrel

Thanks guys! I'm actually going to go with these 295cc injectors from MotorWest: Set of 6 295cc 28lb Upgrade Fuel Injectors for all 3.4L 1996-2004 Toyota Engines HP5194 | MotorWest Performance I think they will give it just enough extra ooomph without having to worry too much about the ecu...

Hey guys I just hit 300k and need to replace a bad injector. I have 1st gen supercharger with air box mod and TRD exhaust - should I mess with trying to source Supra injectors (no plans on further mods) or just get fresh stock injectors (might as well replace them all if I have to tear apart...

Thanks! I've had this in my cart for 2 weeks hoping for a code, just purchased my set!

Perfect, thank you

Anyone know the answer to #1? I can make the shorter ones extended a bit so that they fit on either, but I'd rather put them where they were indended to go. Shorter in front and longer in rear? The bolts themselves, the shorter bolts I'm assuming would go in the front and the longer in the...

Thanks for the heads up, I've been waiting on a good deal on a compressor for a while now and this was perfect.

Thread revival... Doing an install of Clifford 5305X, I've been at it a couple days and just about got it all working. For some reason when I trigger the remote start, the driver's side front door unlocks, the car starts, then locks again. I'm not sure what else to do so that the door never...

I'm done with the tool and looks like the seals are holding. Thanks again for a wonderful program and awesome members!

Mine came in a few days ago, I finally put em on and had to use em this morning! Had to spray water to try and de-ice the windshield as it was frickin 28 here in SE Texas. These things are awesome!

This is so awesome! I was just about to go buy one of those tools on ebay to do my upcoming bearings/seals. Just got the shop press put together this past weekend and about to order all the parts. Do I just pop back on this thread to make a tool request when I have everything ready to start...

Thanks, I'll get up under there and see what I can find. The TSRM just says: "At the time of installation, after installation, check that the breather plug at the end of the breather tube (inside of the LH frame) is not damaged or worn."

Does anyone know where it's supposed to clip to?

It appears to be a breather tube of some sort so I'm guessing it clips up out of the way. It leads back down to the diff, but isn't the main breather line, I have that one extended up. This is a much smaller hard plastic tube, that rubber end with the white dot on it has an "x" cut on the end...

Doing rear springs and shocks and found this cable just hanging loose up near the upper driver side shock mount. Looks like it may lead back to the rear locker, but I'm not sure what it's supposed to connect to. It's the cable with the clip and cylinder end with a white dot on it. Anyone know?

That's where the photos end, I was using the contour line in the rear door as a reference point if that makes sense.