Recent content by kipmc7

  1. K

    TPMS sensors: to replace or not to replace, that is the question.....

    Has anyone used A-Premium TPMS sensors as replacements on a 2007 4Runner? The price for 4 is only $65. How did it work out? The warranty is 3 years. For other manufacturers, like Duralast from Autozone or Autel from O'Reilly, the warranty is only 1 year!!! The A-Premium sensors say that...
  2. K

    Where Can I get the Maintenance Schedule?

    Where Can I get the Maintenance Schedule? Just a simple table showing : Oil Change every XXX Miles or YYY Months Air Filter Spark Plugs (for the V8) Cabin Air Filter Brake fluid Coolant etc. Thank you. My Owner's manual says, "Please refer to the “Scheduled Maintenance Guide” or...
  3. K

    Getting a "Check Engine" after Changing Plugs

    I just changed the spark plugs on my 2007 4Runner after getting a slight rough idle for a few seconds and then the Check Engine Light (CEL). It is also called the Malfunction Indicator Lamp (MIL). I DO have a code reader and there were 4 codes: Too Rich, Misfire-multiple, Misfire Cly 1 and...
  4. K

    How To: HVAC Bulb Replacement - 4th Gen

    I replaced 1 of the 2 bulbs that illuminate the display of Range, MPG, outside temp etc. The round controls for 1) Fan speed 2) Auto/AC and 3) Mode all light up. But #2 the Auto/AC also has temp UP and Down. Do those 2 light up ?????? Everything else lights up but not the Up and Down...
  5. K

    SAIS bypass kit not working?

    I only posted the advice to check the signal wire from the starter relay to help anyone who reads this thread.
  6. K

    SAIS bypass kit not working?

    If your bypass system stops working, or you start getting the same codes as before, the first thing I would check would be the signal wire from the starter solenoid. The instructions only say to "...reconnect it to the started relay as previously connected" The "as previously connected" was...
  7. K

    SAIS bypass kit not working?

    For the SAIS Bypass, Did you also install the Exhaust block off Plates? I installed a Hewitt SAIS Bypass Module the Gen 1 version. This is the "Plug and Play" version. You plug it in and run one wire over to the starter relay. All that was easy. I have not installed the exhaust block-off...

Members online

Forum statistics

Threads
278,309
Messages
3,554,068
Members
248,016
Latest member
Advally Service
Back
Top