Recent content by Leadnuts

I've posted twice to the WTB section once for a tire, once for some wheels. "KiwiG" replied with the tires I needed. Told me to contact him with "atozfries247 (at) gmail". I just about paid for a couple of tires, when he said he was in California.. i figured shipping would have killed the...

If someone happens to have a few in 17” x 8” to 8.5” I’d be interested.

I’m looking for a used replacement for a tire I may have destroyed. My others have about 50% on them so I’d like to match that if possible. BFGoodrich KO2 LT275/70/r17 Might be interested in two if it’s an option. Thanks

Finished making a few more drawers and modified the fridge pullout I found. There was a bit of a learning curve bending the signs around without cracking the edges. I do sort of regret not spending a little more on the slides so the drawers could be removed.

Made a pullout last night and tried it out today. Made from old traffic signs from the scrap yard.

I see.. I did a very similar thing to you but with an aluminum plate and a thin steel tube substructure. I made a contoured trim piece for the back edge, just haven't welded it on yet.

Thanks, I just saw that. Soo is Goose Gear super nice? I see its Baltic Birch Will it hold down with a telescopic pullout? I'm thinking I may have waaaaaaay over built mine lol. I was so paranoid I'd be pulling it out all cool like, then at full extension it would just tip right out to...

What are the Goose Gear plates made of? And how are they attached? I made a plate that covers everything in the back, and I can't decide how to fasten it down? Rivnuts through the steel floor. It adds a hole but then again it gets plug with a bolt, also the two OEM tie downs have threaded hole...

That looks pretty good! I see they had 2 options for the trim. Is the dark option match the trim you removed well?

ok thx

sent you an email. Also, if others need some help with a part, I'm willing to help out when I'm not jammed with working.

Yeah, I can scan it for you. Its Metrology grade. ATOS GOM. I don't see a PM area yet.

I'm new here. Just signed up. I woke up this morning got a cup of coffee, sat down, and googled info about building myself a rear bumper setup... First off i found this thread and site and 6hrs, 7 cups of coffee later I finally get to this last post and can now blink. This is an inspiring...