Recent content by Liam

Rear driveshaft ujoint Sorry to ressurect this, but I want to replace the back ujoint on my PN28 DC driveshaft. I was told to stay OEM, but I can't find the ujoint. I just had a chat with lowrangeoffroad and they said it would work as long as it wasn't with the DC. I told them it was so the...

Thanks for the suggestions. I got the IAC out, but what are the chances it's bad? I am considering replacing it since I've got everything torn apart. Thanks, Liam 97 SR5 4Runner V6 3.4 35" Bighorn mud tires Lifted tall Frame rusted to hell (they won't put it on a shop lift)

I've had some issues with starting and driving my 4Runner, where it would run rough and finally snap out of it after just a few minutes. I changed my plugs (single diode) and it didn't seem to help anything. As it got worse, I planned on changing the wires to see if that helped...

I just ordered a Flowmaster 50 from Advance and they are shipping it for free.

Which Vortex did you go with? The 88101? :toilet3:

What size DST did you end up putting on, and what is your opinion of it so far?

The horror stories I was reffering to actually was in ref ChildrenOfBodom's post. I looked at the YouTube clips today, and wow, that sucks! I am sure there are horror stories on alot of different mufflers, but man, that's pretty scary! So the question is do I spend the money on a Borla, or...

I have a 97 4Runner SR5 V6 and I need a new muffler. I already got a new tailpipe. I want to go with a performance muffler, and I have read different horror stories, ect... I saw a Magnaflow 13255 XL Stainless Steel 2.25" Oval Muffler as well as a MagnaFlow 13255 Universal Satin Stainless XL...

Isn't that a bracket that attaches the end to the bumper? I am looking for one that attaches the end near the tire up to the body. I will try and snap a pic soon and post it.

Ok cool. I figured that was the obvious answer. I just couldn't find one online, and G nows what the dealer would charge. I am going to check the site where I bought the end ($60 shipped). Thanks!

I just got a 97 and need to put a right bumper end on the back bumper. I looked up underneath the left side while it was getting dark last night, and it seemed like there is a bracket that I don't have on the right side. The bumper end I got fit up ok on the back portion of it, but towards the...

Well I stopped by an inspection station today, and they told me roughly what exterior work I need to do. He said the bottom of the body will need to be even with the center of the wheel :wtf: So I will need to remove the body lift, and put on my buddies 30"wheels so they don't stick out. Not...

Ok I added my location. I am in MD. Wish I was closer :0( I am searching for that setup somewhere out here. I have seen the lower valence piece online, @ $60 shipped. May have just order it up. Thanks!

Ok cool, I will look for the plastic bumper valence for now, and then do something else with it once I get my permanent tags. Thanks for your help!

No unfortunately I am not interesteted in talking off the bl nor am I going to sell it. It's staying as is. I just have a feeling the frame ends sticking out is going to easily fail here in MD. It's pretty strict. Do most of or any of the after market bumpers attach to the frame ends at...