Recent content by lordhowe

this is embarrassing:shrug: but i can't find any good pictures on the order in the manual either. can someone enlighten me?

it is a v6 4runner with the 5 speed manual tranny. i actually have the manual but have no idea which section to look at. I just need some guidance from someone that has a little more intuition at PDF manuals than me. thanks!

I replaced the valve cover gaskets (1992 V6 5 speed) and after removing the intake manifold i accidentally pulled off the vacume lines that goes into the intake manifold without labeling it. there are a total of 6 small vacuum tubes that's next to the EGR valve. each tube has a number (1...

very good point! i have a v6 4x4 with auto. it's a 3.0 liter i believe. thanks

I haven't had my 92 4runner (v6 3.0 auto 4x4) for too long but have done a decent amount of work to it to bring it back to normal running conditions. I need to replace/fix the following: 1. Fuel filter, i would like to replace it but don't know where it's located or how to do it. 2...

i will do the test, thanks alot guys

31 PSI? wow that's pretty low from all of the research i have found.... how is your tire wear?

i know the stock recommended tire pressured based on stock tires, but i'm running 33x1250's and wasn't sure what the correct on-road pressure for that tire size....

I have a set of 33x12.50 bfg mud terrains riding on 15 x 8" rims. i was wondering what pressure i should be running them while on road. and what's a good rule of thumb for off road pressure. right now i have been running them at 40 PSI on road and half that in sand. I don't want to wait...

Hey there, when i mentioned other people helping me out i really meant you! since you are the only one that was able to provide any feedback. do you have any particular setups that you would recommend for better front end articulation? I'm trying to stay cheap :) i will search about the...

After reading the posts and help from a few experts here within this forum i was able to do a 4crawler ball joint spacer and rear coil spacer. After some fender trimming i was am able to tuck 33x12.50 bfg mud terrains on a 3.75" offset rims. everything is looking good but i have a few...

I'm looking for some aftermarket bumper for a 92 4runner. as long as it's in decent shape i will take. please e-mail me at [email protected] since i don't check the PM in this site very often. thanks!!

I'm looking at these for my 92 4wd v6: http://www.4crawler.com/4x4/ForSale/CoilSpringSpacer.shtml#Introduction would you think this would provide enough clearance for a set of MT off of the jeep rubicon's? they are 32x10.50's. or even better, could they fit 33's?? thanks!

Hello, A few newbie question that i hope someone is kind enough to enlighten me. i have 92 4runner with a V6 5 speed. it's got 31's tires on there with 15" rims. Can these rims hold 33 12.50 tires? what is the exact spec for these rims? such such as bolt pattern, offset. some lifts...

Hi, i'm new to the forum. very recently i got a 92 4runner with 6 cylinder 5 speed 4WD. I'm looking to do some maintenance myself and was wondering if someone can point me a factory service manual. thanks ahead of time!