Recent content by LTDBLKTRD

Picked up a 2018 trd pro premium in Littlefield Texas on vacation, it was time to trade in my ladies 2014 Hyundai and the cost on t4r’s down in the area was very enticing so she went for it and was happy to get out of the Tucson. It already had a artec bumper, toytec coil over lift, some nfab...

Did you install the jumper wire in the diagnostic port between te1 and e1? Check the under hood tag for the idle setting as well, I’m dealing with timing issues on my 3rd gen 3.0 truck right now, just picked it up and trying to get it running. Me and my dad just got done rebuilding a really...

Had the plumbing done a few weeks ago so the pumps was a quick job. I’ve got a 1 gallon seamless tank as pictured and a airline going to the rear jack storage area to a 2 port manifold which has a gage to monitor air pressure. With this setup i can run a air tool for repairs or whatever

Got my pumps in yesterday, now to tackle the wiring side of things.

Got my pumps in yesterday, plumbing is done and now to tackle the wiring

Nice rig, i used the same pliers to remove my old ones haha

No notch on 5th gens, got mine yesterday and put them in after crackin a beer!

I received a email about the shipment! When will the rears be ready?

I have all oedro led bulbs from amazon, they are the long stem chip (only manf. Of its kind so far) they are in the hi, lo and fog housings they even match my rigid radiance pods output which is nice.

I guess I’ll kick off for Cali raised, I very recently got them off of amazon and just moved my rigid radiance pods up to the new brackets and extended the wiring from where I had them tapped into, no issues with the plastic/ hood seal either.

Just ordered my arb twin finally! Went through morris4x4center cause $517.00 plus free shipping and through the end of August they have a coupon code for $30 off $300 purchase or more aug30 is the code

I ran mine down the driver side rail with the other lines (gas and brake), the block and filter are up by the fuse box in the engine compartment.

Just when i thought i could contribute a bit to this thread, i see the bp adapter... found t on lce though https://www.lceperformance.com/Spin-O-Oil-Adapter-for-1GR-4-0L-V6-Powered-Toyotas-p/1093052.htm

Still selling the bumper?

Thanks but I currently have a hitch mounted step/hook from rbp, apparently it wasn’t enough to detour the mind of a bad driver..