Recent content by macscac

Sent from my iPhone using Tapatalk

I honestly don’t remember what size bolts they were. I just got the risers and then took them to ace hardware and got 2 bolts and nuts that fit. My prinsu rack side slots are aprox 1/4” wide tho so you will be fine The mounts are fantastic. I’m in Arizona so it’s hot. 110+ alll the time...

can't see thru the windows with molle panels attached. no one will see inside very well

The OP makes me feel bad about my own back end... [emoji25] Sent from my iPhone using Tapatalk

curious as to the need of 2 tow straps? is it for distance? or have you been in a situation that needed 2 separate straps to recover? also, coronavirus veteran? hahahahaha!!! please do tell where you found that

yes you can set the height of the shelf as low or as high as the side panels are

thank you. ordered..

Which springs would I need for the rear to get that extra lift? Also, at 23” in the front, is that maxed out height? Sent from my iPhone using Tapatalk

my hub to fender is aprox 23" in front and 24" in the rear currently. will those shocks you recommended give me some additional stretch when im flexing the rear? I am assuming they will not affect the lift at all is my current hub to fender that tallest that I can get all around? thanks!

Crikeymike I need some advice. I would like to raise my rear 1" and replace the stock (rear) strut with something with a little more long travel. what would you advise? i have 2018 trdor with KDSS. This is my current set up. thank you Dobinsons c59-314 in front. 3” lift Front struts...

still trying to confirm how this will play out with a c4 ladder installed. does anyone know? also, I will be using 315/70r/17 ko2's. based on the photos above it looks like theres about an inch(?) of gap between the 265's and the jerry cans. will the 315's even fit? is there some type of...

Here’s a quick photo. If you go to the ICS beefy mount thread, I have some other photos. Sent from my iPhone using Tapatalk

Thanks! I can take one in the morning for you Honestly it’s just a small ram mount and I have my two fmrs handhelds hanging there. Pretty basic Sent from my iPhone using Tapatalk

I originally stated that I wouldn’t have a use for a panel like this but things change... Long story short, I needed to mount a tablet from the ceiling for our special needs son. The install was easy but tricky with just one person. Three hands would make life so much easier. Anyhow, it...

honestly, I did not mount it up there.. I did not want to deal with hiding the wires but mostly, I did not want a big brick up there. it would bug me. I ended up buying a diff CB and mounted it in my center console. I use this dash tray for my phone x-grip(s) and my fmrs handheld radio