Recent content by maddiesel67

How about a sway bar for the 3.5.

Any chance of getting a sway bar for the 3.5 kit?

When will MRA59-A575s be back available?

Is that better?

i found some real level ground and checked again its only about 1/2' low on the drivers side when the gas tank is full. but once i add another 220 to the drivers seat its probably lower any chance of getting a custom C59-801V for 800lb+ carry my b1tch is heavy.. lol i have 701s but could use...

Do the doninsons rear springs left right compensate for drivers side lean ? I just installed c59-701's and the drivers side is an inch lower then the pass. side. No kdss. Should i swap the springs? Add a spacer. Im assuming the shop that instaled them put them on the right aide if they were labeled.

roots type chargers usually make power much lower then centrifugal so id imagine the peak is lower then 6500. probably a little lower then factory hp - 5600 tq - 4400

i did the full shrockworks setup bumper and skids hopefully it will be here in a couple months..

interested to hear what the dealer says haha :snacker:

anyone? i have to make a decision by monday. at this point i think its smart to back it down to 4.56 as im only running 33.5's currently and not planning on going bigger then 315/34.5

when your done it would be cool to get a full breakdown of what all broke haha

I have read the front spring rate for fj/4runner is 600lbs.

Ill be interested to hear the deets my cbi should be here in a week or 2. :juggle:

How you like the 23zero? Have you used or seen any others to compare ?

where did the cbi bumper break? what needs to be redesigned?