Recent content by manualdr5

Clutch replacement timeline Hello, It was a big job for me given that I did it solo and without a hoist! Just a couple of 3 ton jacks and a lot of patience. In retrospect I would not do this job again without a hoist and a proper tranny jack. The most time consuming part of the job for me was...

What a GREAT article, Thank You! :thanks:

I can buy whatever I want but that isn't the point. for me I was just telling my buddy how much I enjoy driving my truck and going through the gears. It just keeps getting better with age!

Finally resolved my issue! After months of guessing I finally figured out that the clank was coming from my drivers side rear lower control arm! Had the bolt torqued down to spec and voila no more noise!

Updated MAP, Dome and Trunk with LED Cheap, easy and well worth it! I bought a few bulbs and kits before realizing that my particular truck uses BA9s bulbs for the MAP and 31mm festoon bulbs for the dome and trunk lights. Before purchasing bulbs make sure you know what bulbs you need or just...

ScanGauge II Mounted I installed my ScanGauge II in place of the ash tray. Removed the ash tray and the metal mounting bracket. I then used a dremel to trim down the edges to allow the scan gauge to fit flush. I secured the scan gauge using a velcro strip. A very simple install.

2000 4Runner SR5 5 SP Lots of stuff

It's official front end done! The front end is finally done with one minor modification to the light bar placement left to be done. The rear swing out arm will be done this week with my new 4xinnovations hinge, wasn't happy with the one supplied by coastal offroads swing out arm, pics soon to...

Another question, since I'll be getting power from my secondary fusebox wouldnt that result in constant power to my halo? Sounds like I'll need to setup an ignition relay to my secondary fusebox?

Thanks for the link Durk! I bought the Hella relay with the waterproof relay connector with 12" leads. I'll just cut off and insulate the #87.

Thanks for the advice, planning to go this route. Just wondering what you do with terminal 87?

Front bumper in raw steel Here's the front bumper before I pulled it off to get sand blasted and powder coated. I have a pair of rigid dually's I'll be installing in the square slots. Covering up the turn signal holes for now.

I've also gotten, straight out of Transformers, I think I like terminator better lol I should have the bumper back from powder coating next week ready for my road trip to michigan to pickup my TRD cat back exhaust :)

SRQ Fabrications filler panel

HID Headlights with LED Filler Panels Finally installed after I got my core support installed! I'm 90% done just waiting for a relay so I can setup the halo as my DRL. I want it on when I turn on the truck but off when my headlights are turned on. Here's a quick preview of the amber lights...