Recent content by marco2379

Final update (hopefully), I found out how to remove my bearing today by following directions at http://www.4x4wire.com/toyota/maintenance/front_end/ Now even though my wheel should no play when rocking it back and forth with my hands at the 6 & 12 o'clock positions there was still heat marks...

Today I checked the CV joint and replaced the inner boot on the drivers side, all movement was free and no signs of damage. I wanted to get to the bearings but have no clue as to how to get them out. I have a 1994 4wd with A.D.D., my Haynes manual doesn't even seem to cover bearing removal for...

Okay, I'll narrow the drivers side wheel grinding noise down to this: The noise occurs when: -driving straight in 2wd (will continue while turning as well) -noise occurs no matter what gear or speed (5speed manual) -the temp gauge is always in the normal range (middle) -noise occurs after about...

Well I managed to get the vehicle on jack stands and recreated the sound while in 4wd, its the only I could get the front wheels to spin fast enough. Unfortunately I couldn't be under the truck to get a good listen and hold the accelerator simultaneously. Still can't pin point exactly, but...

I think I have the same problem with my 94 4runner. I don't have the clunking sound but after driving about 2 minutes at normal speeds (in 2wd), I hear a grinding sound coming from front drivers side wheel well area. I have replaced the brake caliper, brake pads, checked the bearings, replaced...

Hello All, I have a 1994 V6 4wd 5speed 4Runner that is absolutely whipping my behind in the garage. I'm trying to pull the tranny to change out the clutch. I managed to remove all bolts from the bell housing (Even the ones on the very top), crossmembers, drive shafts, and starter but it still...