Recent content by MattRagle

Okay so in the next couple of months I intend on swapping my 99 Limited 4x4 from auto to manual. I have tried searching the forum and found nothing on the subject so if there is info here please send me a link, if not has anyone done it? I have already priced a brand new trans at around $2000...

Had a P0120 code so I replaced my TPS code is now gone but I notice my speedometer isn't moving until I hit about 10mph then it comes up and moves where before it would read under 10 it wont now. Any clues?

Has anyone used the TPS from NAPA?

It's a 99 Limited 3.4 the closest dealer I have is about an hour away. Figuring I may just buy one from AutoZone or NAPA.

My runner is throwing P0120 and when the light comes on it has no power to accelerate uphill. When I reset the light everything is good up until the code throws then back to no uphill power. My question is has anyone replaced their TPS with a $40 part from amazon? If so did the part last?

What brand MAF did you put on, maybe it was faulty?

I'm not so sure you being on here and being a smartass is beneficial to anyone on the forum. I came on here to see if I could find an answer and you think that's funny good for you but if I ever have a reason to post on here again after you deciding to be childish please feel free to keep your...

Drove almost 100 miles today no issues so far and I don't expect them to. I drove on every road type in my area. (County roads, Highway, Interstate, and City Streets)

I'm hoping I can close it out by the end of the day.

I'm going to double check everything tomorrow drove it a couple miles down the road without a hiccup nothing looked out of place and ran just fine. No CEL yet either.

I think Roc Doc was right and it was just burning off the cleaner, although it was dry when I put it back in.

mashed the pedal and and it stopped immediately. Right before I unhooked the MAF and it sputtered and tried to die then when I hooked it back up I hit the gas and everything went to normal except my driver side low beam

I got it figured out but another thing i didn't mention is my driver side low beam is now out and even with a new bulb doesn't work any ideas there?

Just went out and started it with my brother in law watching under the hood. The throttle cable isn't moving at all yet its revving to almost 7k

What would cause it to go wide open to clean off the cleaner.