Recent content by mbshaw88

Interesting 60919 uses the 46127 cylinder - Ø4.9" x 6" Do you remember how many bump stop sections you cut off?

Bought Kit 60809 from Amazon which says its compatible with my 2010 4Runner Limited. The amazon reviews and customer pictures show plenty of 5th gen 4runners using 60809 I cut 2 sections of the rubber bump stops off and had ONE HELL of a time getting the 60809 bags in the springs but I was able...

I currently do not have either of the license plate bulbs in their sockets. And I also have the #6 green wire cut at the O19 Junction connector. All other bulbs are back in in their respective sockets and working correctly. When I take a resistance reading at each license bulb connector...

Yes I did unhook the center brake LED before doing the continuity tests. I ended up cutting the #6 wire at the O19 junction Connector (the green wire going to the license lights) and haven't had a blown fuse in 2 days. I figured I could splice it back together once I find the short at a more...

During my previous driving test table, yes all rear bulbs were removed during the first step, then reinstalled step by step thereafter. The white cells with the dotted lines meant the bulbs were not installed during that test. The only thing I didn't know at the time was that the front side...

Tested everything last night step by step and somehow I couldn't get the fuse to blow. The only thing I noticed was when I placed the license plate bulbs in they didn't turn on right away, I had to push them in a little more then they turned on. Drove around about 20 minutes total with no fuse...

Thank you! I'll post an update tonight to see if pulling the bulbs still results in a blown fuse.

My 2010 4Runner with no electrical modifications keeps blowing the 10A Tail/Stop lamp fuse. There are two fuses for these lights: one under the hood(10A Stop/Tail) and one near the pedals in the driver's side instrument panel fuse block (10A Stop/Tail). The one near the pedals is the one that...

huh, I tried it on 2 different computers and my phone and they all opened fine. Here's the link to where I originally found it. Try this: http://www.toyotaparts.metro-toyota.com/ECM_Calibration_Enhancement_to_shifting_performance_TSB016610.pdf

Here is the pdf for this TSB. If WhiskeyCop wants to link it to his first post. I couldn't find it anywhere else on this site.

Thanks I'll definitely take that to heart. I guess I didn't think a lot about possibly making the situation worse. The only thing I was worried about is that thread was obviously back in 2010 when the issue was hot and the vehicles getting reflashed had very low mileage. Mine has about 60k and...

Thanks, I appreciate the reply. It's just that my car fits within a very small window of VIN numbers with a shifting map problem from the plant. The people below had the same issue, got the ECU flashed, and it was fixed. The whole thread is exactly what my symptoms are and people posted it...

I bought my '10 Limited last year and have been loving it except for this weird issue where it can't seem to find the right gear between 1st and 2nd during downshifts. It's very noticeable in stop and go traffic when I'm going in and out of 2nd under 20mph. Well a couple days ago I decided to...

-2010 Limited -58k miles -Daily commuter, mostly highway use The past two or so months I've been noticing my T4R is getting louder and louder while driving. It's not an irregular sporadic noise, but more of a humming constant rolling resistance type noise. I bought it last April and I don't...