Recent content by Mburr

I keep my dog back there but he hasn't touched the seatbelts. That being said, I have them tucked into those clips so I don't think he sees them there.

Seems like there are a few people with this issue: Mine was going both warnings on, then a few days later both would go off. Happened 4-5 times over 4 weeks. Toyota gave me back my truck yesterday, the work order says: Cause: Replace #PO705 = Open circuit in shifter switch Correction: Replace...

And another update - Toyota Head Office decided they are going to change the transmission computer/circuit board/chip. They say that should fix the trac. control error message. Will let you know

UPDATE - The 'top service guy' at the local dealership is stumped. They are sending the diagnostic reports to Toyota Canada head office for evaluation. Funny enough - 1 hour after getting the car back, lights went off and everything worked again. I'll have more news this week I think (hope)

Sorry for being vague. It's a 2011 SR5. The issue is with the transmission, not the 4x4. I can move in and out of the 4x4 easily, but when this check engine light and Trac control lights are on I don't get any help with traction.

Ladies and Gents, Two weeks ago, on the eve of a short road trip though the snow belt... Engine light came on, traction control light came on. Traction control wasn't working. Did the drive anyway, 4wheel drive worked and 2 days later the light was off. Toyota said they've seen something...

The range is based on an average gas consumption over a past time period. If you do mostly city driving your average will be low, highway it will show higher.

Thanks gents! I'll get creative see what I can muster up.

Yeah, I know where the crack is and was hoping to remove the outer layer, dry it out and seal it again. But can't get that off... I hate to bite the bullet and buy a new assembly. What are the thoughts on drilling a small hole at the bottom to drain and then fill it with a silicone?

I've got condensation building up in the tail light of my 4Runner and is pooling in the bottom. Can someone help by explaining how to pop off the stop/turn light cover so I can drain it? I'm not sure where to pull and pop it off. THanks all