Recent content by monkeyskeeper

parked next to a 09? sport last weekend at the mountain, and really liked his tube steps over my runner boards on my 07 v6. I would say the aries that I found in black would be a near identical match.but it looks like they stick out a bit more than the OEMs. Only $170 on Carid.com, Try to find...

still available? how many miles on them? and how much abuse did they see?

same issue, leaking strut and now four 5100s I had the same issue that you did, Maineiac. Bought Daystar kit, went to install it and found leaking front strut. Bought all four 5100s and Fj coils. The ride with the Billies is way better than the oe. Used the daystar rear spacer and set the front...

Just did this last weekend, fj springs, 5100s, daystar 1.5, and ome fj trim spacer. the driver side was a tighter fit, but with the frame on jack stands, track bar disconnected, shocks off it is possible. I lowered the rear end down on a jack to get the clearance needed. the brake lines go...

status on springs

take the high road and return the tool. nothing worse than losing anything with a snap-on logo, that comes out of my pocket, not the bosses. and as a paying customer the service dept should offer you something for the money you spent, only to be concerned.

just found cheap tires. which do you think? just came across good used tires throught a demo program. which do you think would be my best option, with the stock springs and 5100s ? -265/70/17 bfg km2 or -255/75/17 bfg mt looking for some feedback, and or fitment issues

no aftermarket bumper in the future, this is my fiance's rig. Just going for a higher more proportioned look, ie spidertrax and new springs(soon).

thanks for the feedback thanks for the feedback. Sounds like I am running the 5100s and stock springs to get the 2.5 I am looking for, until I can find FJ springs or something comparable. what do you have to do as far as wheel well mods to fit the 285/70 /17s with that setup?

I am new to this site and am slowly acquiring parts for my fiance's 07 Runner. I currently have a daystar kit(2.5/1.5) and bought Bilstein 5100, due to a leaking seal, but haven't installed them. Can I run the 5100(on the lowest setting) with stock springs and the daystar kit until I can get the...