Recent content by Mr.Edd

  1. M

    K&N air filter

    Hey Fellow Runners, Does any of you happen to have the k&n air filter part # for the TRD Cold Air intake box? :thanks:
  2. M

    TRD Cold Air Intake

    Thank you That’s all I needed to know.
  3. M

    TRD Cold Air Intake

    Hi Fellow Runners..! I just got my new used toy. A 2016 4Runner SR5! but I been the owner of a 1997 4Runner with 300,833 miles and still kicking!!! Thank U to you all Fellow Runners! And to T4R.org! I have learned a lot from all your post and 4 helping each other. The reason for this post is...
  4. M

    FYI Products

    Steering pump How much for a power steering pump for a 97 4Runner 2.7L base model. Automatic transmission? Thank You
  5. M

    Cargo Area Speaker Issue HELP!!

    It sounds like a blown speaker. Have u check it? To make sure if is blown? It also sounds like if u are pinching the speaker wire? Have u installed anything that might pinch a wire?
  6. M

    Noise after spark plug install

    Did you check the wires?
  7. M

    Drain Plug no gasket?

    Plug gasket Most of the time u don’t, but it’s a good idea because if you used a gasket you don’t have to over tight the plug. I have a 97 4Runner and I never used one.
  8. M

    Really Strong Gasoline Smell

    Have u check the bottom of the fuel neck? The fuel neck to the tank has a rubber gasket. When it wears out the fumes come out. Have u replace the fuel filter? If u have check it. If u haven’t it might need one.
  9. M

    Painting accessories

    After sanding make sure you use some primer. That helps a lot to cover any imperfections that the sand paper leaves behind and it helps the paint you are going to use afterwards.
  10. M

    Tapping into 12 volt cigarette lighter

    That should work. For ground you can just tap into the metal frame of the car. But just remember that some cigarette lighters are always on. So I don’t know if that’s going to be an issue for you.
  11. M

    Help I dont know what to use!!!!!!(PIC)

    It looks like the clear is gone. That would be a good idea just light sand it and spray some satin clear and it will look new again.

Members online

Forum statistics

Threads
278,309
Messages
3,554,070
Members
248,016
Latest member
Advally Service
Back
Top