Recent content by napstermike

i had no idea it was different from front to back. i thought it would be the same measurement across, all the way down the sides

I need the measurement from one side of the rail where the screws go into the roof to the other side. I believe its about 42 inches but I need confirmation for a project. I dont have access to my vehicle until 7-13 so I need your help thanks in advance

frame and under door pics frame and under door pics

4runner still for sale still available. let me get some pics of the front flaps for ya.

sold 4runner sold. mods please delete

no gasket or sealant between motor and tranny. can you post a pic?

PRICE REDUCED FOR QUICK SALE!!! $19,000 My 2005 Lexus GX470 is for sale. This is the SPORT model with the sought after KDSS Suspension system! The vehicle is dark grey and has ivory leather interior with the black interior accents. The vehicle has 116,000 miles on it and had the timing belt...

Subaru: 1989 ish, Ej, Eg series engines. Up to about 2007 or so. When I had my Sti, I could have the engine in the air in a half hour. when i pulled my 1999 4runner engine, i just pulled the connectors off the ecu like stated above. manual trans so no wires other than the O2 sensors. you can...

the first kit you posted has a pipe on the water pump that goes to the oil cooler on the d/s of the lower engine block. the second kit does not have the pipe and is for the non-oil cooler engine. check behind (front to back) the oil filter on your engine and see if you have a silver colored...

heads whats the reason you think you need new heads? where in nj are you?

nice large piece of plastic will be launched in the cabin next time the passenger bag goes off!!!

looks like the wrong front bumper was replaced as there are no bumper flares

well, I would be but the engine is already pulled out. I was just asking if it was a good idea to send them out. At a price of $15-23 each, I think its good affordable insurance to have them cleaned.

so I bought this 99 4runner with low mileage (225,000 haha) I just got done pulling the engine to do maintenance items (t/b, w/p, valve job, pcv, radiator, clutch). I was wondering if I should send my injectors out to get them checked and cleaned? i want to button up the engine and have no...

i understand that saying, i usually go by it but if figured since the engine was going to be out, the job would be alot cleaner and easier. the vehicle shows no signs of overheating i just figured for another what $150 or so to do them. im gonna run a compression test this weekend with the...