Recent content by Nasty

Thanks. That's an awesome idea! I think that'll be the next project this weekend.

Yes it is the best he can do for camber. He said it's not that far off out of spec and shouldn't cause uneven wheel wear.

Yes those are the OEM Bridgestones. 1.5" Daystar spacer for the rear. Looking to upgrade tires after I get more use out of these. Will either go with the same size or 275s.

Sure just took some at Lake Mead today.

Installed my 5100s 2 weeks ago and finally got it aligned. Took it out to Lake Mead today. Thanks to everyone that contributed info on how to lift a 5th gen! You guys were right. Reinstalling that sway bar on a vehicle with KDSS can be a pain!

Issue was resolved. I went to a reputable shop however, it was a classic case of forgetting/failing to tighten bolts down. He went under to re-torque the bolts so not exactly sure which one was the culprit. No adjustments were made and now it drives normal again.

Looking for possible suggestions on my issue regarding alignment. I installed bilstein 5100 set at 1.75 inches two weeks ago. After the installation I was expecting the alignment to be off or the steering to feel funny. I was glad that when I took it for a test drive and driving a couple miles...

For Sale: 2014 Trail OEM shocks / struts, front and back Full set of shocks front and back. In very good condition and only 8k Miles on them. OEM. $130 with free shipping anywhere in the Continental US. It comes with the bushings and nuts seen in the picture.

6112 Hi guys. I have a set of 5100s for all four sides but I am now considering the 6112s. For those of you that have installed it, how does it compare to stock or 5100s? Any issues with the thicker shocks and springs as far as rubbing or interfering with KDSS for those of you that have it...

That turned out great! How are the 6112s as far as feel? Been waiting on someone to review them. Can you share more pics?

4Runner lift shop recommendation in Las Vegas Can someone please recommend a shop to install my Bilstein 5100s here in Las Vegas? Looking to get all 4 done with rear 1.5 spacers. Was planning on DIY but have been busy. I can't wait!

Pretty good attention to detail there pokits! :AK47:

Front and rear valence dipped Today I plasti dipped my bumber valences. Not sure if this has been mentioned before but a real easy way to make clean lines is to insert a stiff piece of paper in the small space between the bumber and the valence. I used stiff glossy magazine covers. They were...

Do you have any pics on level ground? Love the look!

White TEP Does anyone know if Nguyenn's 4runner has a lift or is it stock height? I really like that look.