Recent content by Nathan97Limmited

Have not figured out the issue yet. At some point ill take it to a machinic, to see what they think it is. I have tried moving the drum and wheel from the other side and nothing changed. In the video the wheel lug nuts were torqued down to spec. Probably not the best idea but I've just been...

You cant really see it but you can defiantly hear it and the other side does not do it. I'll try to take another video at a better angle when i get a chance. feeling defeated on this one. I just been driving it around as its my daily driver. Thanks for all the reply's! 3gen 4runner wheel play...

Hello! Two bearings from NAPA one Bearing from Toyota one bearing from Rock Auto but its the same one as the Toyota. Pressed off the bearing and the axles seems fine to me. It seems this stuff always happens to me!

Alright so I may have been lazy and just replaced the bearing housing with a new one. NO LUCK, still have the exact same play. At this point I've gone through 2 axles 3 or 4 bearings and 2 housings. I am stumped. Thoughts Anyone? Could the only thing that it could be is the 3rd member / Rear...

https://www.toyota-4runner.org/attachment.php?attachmentid=411549&stc=1&d=1716677348 Is this the piece to measure? its the the one I ordered.

But I thought the bearing does not sit in there? Like it just sits in the housing and and on the axle and the ABS ring just spins in that space?

I did noticed when removing the bearing from the housing after I got the axle out that it basically fall out like I just hit it twice with a hammer and it came out BUT the same thing happened to Timmy the tool man in his the video. Unfortunately there is no 3gen 4runners at the junk yard...

There is zero play on the driver side and maybe 1/4 inch on the passenger side. It is bad enough that shops wont do an alignment.

I've tried two different housings the first one i tried to put a small shim in with no luck but maybe. They are crazy expensive from the dealership for a new one. I'm aware the bearing doesn't sit here. Only photo I got from the last job I did.

Sorry I should have said they play is up and down and side to side I don't remember there being any in and out. And the bearing I believe is pressed in all the way followed the video and got it on far enough to put the C clip back on. The housing seems fine but it did not take much for the...

Hello, I have looked every where and no one seems to have the same problem. Any input is appreciated. So got a 1997 4runner two years ago and the passenger side rear wheel bearing was bad or so I thought, there was a bunch of play. So I replaced the wheel bearing using Timmy the tool mans...

Bingo! It was the timing on the Cams they were very very off most valves on both sides were opening at the same time. Got them back to the correct position and it started right up. Cant believe who ever had this engine before me would take something like that apart and not have the know how to...

Ok so, I checked the timing belt sprocket at the bottom of the engine did not see any issues there all the teeth for the crankshaft sensor are there, nothing seemed wrong with the crank shaft key. The MAF seems to be good as well put some cleaning spray through it and checked the ohms. I also...

thanks for the help. I was thinking this too I put on a new Crank shaft pully bolt but the new timing belt was already one so i left the gear for that. My question is could they but the timing gear for the belt on wrong? I thought that gear had a key as well as the gear that sends a signal to...

Thanks for the reply! I'll get that app and see what else I can find out. for the MAF sensor I believe its working because if I remember correctly when i was cranking over the engine the OBD2 code reader I have was telling me the amount of air coming through the MAF sensor. For the wiring...