Recent content by NeutronJon

Five days ago I purchased a 2015 Highlander Platinum for my wife with 19k miles. Last night we discovered water dripping from the headliner around the sunroof console area. The car had been exposed to several rain showers in the past few days, but this was the first time it was parked at a...

http://www.toyota-4runner.org/4th-gen-t4rs/147784-lower-control-arm-replacements-7.html#post2649567

I used remanned ones from Advance Auto parts. Lifetime warranty. I have had two more frozen calipers since then, both times swapped for free under warranty including replacing the glazed rotor and new pads. Buy online so the receipt gets emailed to you. Just print it out and take in the carcass...

I was in the same position as you about 18 months ago. We ended up going the Odyssey route and bought a 2012 and I'm now regretting it. The power actuator for one of our rear doors ate itself and the dealer quoted 1100 to replace the actuator. I told them to shove it and took it home to work on...

Okay... After hours of research on T4R about what to buy, - and a week and a half of minor setbacks at the shop - I FINALLY have my truck back. But, I should start the story at the beginning. My old tires were Goodyear Wrangler Silent Armors in 265/65r17 with about 5-6/32 left on them after...

I had the same problem a couple years ago with my 05. Took the dealer 3-4 hours of work with an air hammer to break them loose. He still only charged me $300. Worth... every... penny!

My shop just called... they've had it since yesterday and one of the LCA bolts is still stuck and they don't expect to be done today... :(

I couldn't get the tubes disconnected without the Toyota tool so I just cut them.

I called conicelli and this is what they told me over the phone after checking my VIN. Your mileage may vary

I did this swap a few years ago. All of the work can be done from under the rig and no need to pull anything in the interior apart. If I recall correctly, the air bags are installed by pushing them up through a keyhole slot, then rotating them in place and a metal clip is installed from the...

Front bolt: 90119-14120 qty 2 @ 5.74 = 11.48 Front Cam: 48409-60020 qty 2 @ 14.04 = 28.08 Front Nut: 48452-35020 qty 2 @ 14.95 = 29.90 Rear bolt: 48190-60020 qty 2 @ 11.07 = 22.14 Rear Cam: 48198-60011 qty 2 @ 10.66 = 21.32 Rear Nut: 90179-14069 qty 2 @ 1.21 = 2.42 Hardware: Sub-Total...

Hey group... I'm getting ready to install Camburg UCAs (and other goodies) that I picked up from another forum user. The kit was missing one of the bushing washers, so I am trying to track down another. Toyota wants $15 for a set of two, but the OEM design appears to only use two washers per...

This one looks like your photo, but the application data shows it's for the V6. Toyota 4Runner (2003-2009). #3290760070: Automatic Transmission Oil Cooler Hose. Automatic Transmission Oil Cooler

Same here. I like the plan for power washing them. I was considering looking for a local shop that will sand blast them for me. Any ideas on if powder coating will hold up in the undercarriage?

Glad you found the solution! I have a set of 1A LCAs on my dining room table right now that are set to be installed next week. I spent about 130 on all new cam hardware from partznet and will be doing OEM hardware. Also going in will be Bilstein 6112s set at the second notch, a 3/8" drivers top...