Recent content by NY-T4R

This should take care of it. http://www.toyota-4runner.org/4th-gen-t4rs/124180-steering-column-clack-resolved.html

From Toyota Dealer. Part # 90010-09017.

You just need a bulb. Here's a great link. Center Console Lights

I am surprised you were able to move that joint... I thought the shaft had groves in it which the bolts line up with...therefore un-movable. huh. Any way, I resolved my rattle by tightening One bolt inside near the firewall. CLICK HERE FOR THE WRITE UP / PIC

319mm for 16" , 338mm for 17" If you put the smaller on the 17" set up it'll go on just fine....BUT..the rotor will rub the dust shield and make a Horrible noise. BTDT, wasn't paying attention when ordering. So in my humble opinion, if your truck came with 17" then get the 338mm. If you or...

Bump from page 12. Surprised there's not more people with this issue. Maybe "Clack" isn't the correct word....best I can describe it though.... "Rattle" would work too. I have only had the 4Runner since December and this issue was making me wish someone would pull out in front of me while...

Glad to see your issue was resolved with the back seat tape trick. IF you or anyone does eventually have squeaking from the tail gait , a dab of grease on the rubber bump stops goes a long way.

Sorry, Inside behind the break pedal. Hope this helps.

2003 Sport Edition, V6 , Tilt / Telescope steering wheel. Symptom: "Clack - Clack" sound in steering column when going over bumps: expansion joints, pot holes, Very bad over gravel / washboard. Resolution: Behind the break pedal at the firewall remove 4 plastic nuts holding on a cone shaped...