Recent content by nycHorn

Had my state inspection done at Toyota of Richardson (TX). Going in I knew my boots were leaking. They said that I needed the CVs replaced for $1200. Needless to say I am going to get a syringe, grease, and some clamps and cross my fingers. If that doesn’t work I might try a local mom and pop...

ToyTec 3” inch front spacer kit. Bought it for a ‘07 runner.Purchased from Bilstein lifts. Bolted on but never used, went with coil overs instead. Paid $179 will let go for $125 shipped to conus...

TRD radiator cap. $30 at Toyota. Have an extra one I’ll send for $15 shipped. SOLD

I bought those exact same wheels from him about 3 months ago. Wheels are OEM and arrived fast. They fit my 07’ SR5 perfectly. Valve stems will fit. Would by from them again. Sent from my iPhone using Tapatalk

6x9 components in front and 6.5 coax in the rear, i also amped them using 4 channel amp. I need a sub to round it out and give me some bass. For the brackets I just used the ones on my stock speakers and “altered” them a bit. I have a 2007 SR5. Sent from my iPhone using Tapatalk

Have one from a ‘07 SR5. Sent from my iPhone using Tapatalk

Makes sense. I do the same thing around the venting around house to keep the critters out. Sent from my iPhone using Tapatalk

Looks good. Where did you get that? Were you able to put in the air bag? Was it hard to do? Sent from my iPhone using Tapatalk

Nice clean build. Wish I had the time and the skill to do half the stuff you pulled off. Sent from my iPhone using Tapatalk

3rd row seats from 2007 SR5 grey. Never been sat in. Dallas area, make me an offer. Sent from my iPhone using Tapatalk

That’s a good idea. Do you have a pic of that? Sent from my iPhone using Tapatalk

Isn’t the fender liner completely removed when installing an aftermarket armor bumper? Sent from my iPhone using Tapatalk

Is the stuff getting into the airbox while wheeling or from everyday driving on paved roads?

I was thinking about doing a front bumper replacement and figured that the fender liner would need to be removed anyways. The only negative I can see for now is getting gunk in the fog light housing. Sent from my iPhone using Tapatalk

I’ve cut so much of my fender liner I might as well remove it. Have any of you guys done this? Consequences? Sent from my iPhone using Tapatalk